Powermate PCV43.2 Manual Del Operador página 9

Operation
(Continued)
• Save all instructions
C
Starting the Engine (Continued)
Starting a Flooded Engine
1 . Place the cultivator on a flat surface .
2 . Move the ignition switch to the ON position .
3. Move the choke lever to the 'run/ warm start' position.
(see Figure 7)
4 . Hold the throttle trigger fully depressed in fast position .
(See Figure 10)
5 . Pull the recoil starter handle repeatedly until engine
starts and runs . This could require pulling the recoil
starter handle many times, depending on how badly the
unit is flooded .
6 . If the engine still does not start, allow the unit to sit for
about 15 minutes, and repeat steps 1-5 .
D
Adjusting Engine Speed
NOTE: This cultivator is equipped with a centrifugal clutch, so the tines will not turn until the engine speed is increased .
To increase the engine speed, lift up on the throttle trigger . (See Figure 10) To slow the engine down, slowly release the
throttle trigger . Completely releasing the throttle lever will return the engine to idle and will stop the tines from rotating .
E
Stopping the Engine
1 . Release the throttle trigger and allow the engine to idle
for a few moments . (See Figure 10)
F
Adjusting the Drag Stake Position
The drag stake adds resistance when cultivating which
makes the unit easier to control . It also can be adjusted to
change the depth of cultivating . To adjust the drag stake
position, follow the steps below and refer to Figure 11:
1 . Remove the detent pin
2 . Slide the stake to the desired position, aligning the hole
in the stake with the holes in the support bracket
3 . Insert the detent pin through the holes to secure the
drag stake .
NOTE: For the deepest cultivating depth, set the drag stake in
its lowest position . This will give the greatest resistance and
allow for the deepest depth .
G
Adjusting the Wheel Height
1 . Loosen knob .
2 . Move the wheels up or down .
NOTE: The upper position is for cultivating, the lower position
is for transport
3 . Tighten knob securely after adjusting the wheels to the
desired height .
Questions? Call Toll Free at 1-800-737-2112
NOTE: If the unit still doesn't start, refer to the
TROUBLESHOOTING section of this manual or: If you
need assistance or have any questions, CALL TOLL FREE:
1-800–737-2112 .
FAST
SLOW
2. Move the ignition switch to the 'stop' position.
(See Figure 6)
Knob
ENG - 9
Copyright © 2018 MAT Engine Technologies, LLC
Holes
Detent Pin
Support Bracket
Wheels
Fig. 10
Drag stake
Fig. 11
Fig. 12