Operation; Important - Powermate PCV43.2 Manual Del Operador

Operation

• Save all instructions
A
Before Starting the Engine
Mixing Fuel / 2-Cycle Oil
WARNING
Do not smoke or allow smoking near fuel or the cultivator .
Mix and pour fuel outdoors WHERE THERE ARE NO
SPARKS OR FLAMES .
The 2-cycle engine on your cultivator requires that fuel and
2-cycle engine oil need to be pre-mixed before adding to
the fuel tank .
WARNING
Always mix the gasoline and 2-cycle oil in a container
approved for gasoline . Never mix fuel directly in the engine
fuel tank .
Use fresh unleaded gasoline with an octane rating of 89 or
higher and less than 10% ethanol .
Use 2-cycle oil that meets or exceeds JASO – FC
specifications and is intended for mixing at a fuel to oil ratio
of 50:1 . We recommend the continuous use of a 2 cycle fuel
additive/stabilizer to counteract the effects of ethanol .
These additives also prolong the shelf life of gasoline .
B
Adding Fuel to Cultivator
1 . Stop engine and allow it to cool before refueling .
2 . Place the unit upright on the ground or on a sturdy
bench and wipe away any debris from around the
fuel cap .
C
Starting the Engine
Starting a Cold Engine
1 . Place the cultivator on a flat surface .
2 . Move the ignition switch to the "on" position . (See Figure 6)
3. Move the choke lever to the 'cold start' position.
(See Figure 7)
4 . Press the primer bulb slowly 6 times . (See Figure 8)
5 . Grab the recoil starter handle with your right hand, and
support the cultivator with your left hand . (See Figure 9)
6 . Pull the recoil starter handle sharply until the engine
starts and runs
7 . After engine starts and runs for 10-15 seconds, move
choke lever to "run/ warm start" position . (See Figure 7)
Starting a Warm Engine 1 . Place the cultivator on a flat surface .
2 . Move the ignition switch to the "on" position . (See Figure 6)
3. Move the choke lever to the 'run/ warm start' position.
(See Figure 7)
4 . Grab the recoil starter handle with your right hand, and
support the cultivator with your left hand . (See Figure 9)
5 . Pull the recoil starter handle sharply until the engine
starts and runs .
Questions? Call Toll Free at 1-800-737-2112
NOTICE
Use of incorrect gasoline such as diesel fuel or gasoline
containing more than 10% ethanol or methanol will damage
the cultivator engine and void your warranty .
NOTICE
Use of incorrect oil, such as automotive oil, 2-cycle marine
outboard oil, or any oil other than specified oil will damage
the cultivator engine and void your warranty .
To mix the fuel and 2-cycle oil, follow instructions on 2-cycle
oil container for mixing fuel . Mix gasoline and 2-cycle oil
at a ratio of 50:1 . A mixture with a 50:1 ratio is obtained
by mixing 1 gallon (4 liters) of gasoline with 2 .6 ounces of
oil (77 ml) . After adding oil to gasoline, shake container
momentarily to ensure proper mixing .
IMPORTANT: Mix only enough fuel for your immediate needs. Do
not store pre-mixed fuel.
3 . Remove fuel cap slowly and use a funnel to pour the
mixture into the tank, and replace the fuel cap .
4 . Avoid spilling fuel or oil . Wipe up all fuel spills .
5 . Move at least 10 feet (3 meters) away from fueling site
before starting engine .
ON
PRIMER BULB
ENG - 8
Copyright © 2018 MAT Engine Technologies, LLC
RUN/WARM
START
Fig. 6
Fig. 8
COLD START
Fig. 7
Fig. 9