Black and Decker G720 Manual De Instrucciones página 14

ENGLISH
• Press in the spindle lock button and rotate the spindle until it locks (Fig. 3). Keeping the lock button pressed in, tighten the outer flange with the
spanner provided.
FITTING SANDING DISCS (FIG. 4)
• Use a sanding disc with the backing pad for sanding with your angle grinder.
• Disconnect the plug from the electricity supply.
• Remove the guard.
• Place the flange on the spindle. Place the backing pad on the spindle and inner flange, ensuring it is correctly located.
• Mount the fibre backed abrasive disc on the backing pad.
• Fit the threaded outer flange and tighten as explained in "Fitting the discs".
HANDY HINTS (FIG. 5)
Hold your angle grinder firmly with one hand around the side handle and the other around the body of your angle grinder.
• Always position the guard so that as much of the exposed disc as possible is pointing away from you.
• Be prepared for a stream of sparks when the disc touches the metal.
When grinding, always maintain the correct angle between the disc and the work surface (15°) (Fig. 5). This increases the removal capacity of the
disc and avoids unnecessary overloading.
OVERLOAD
Overloading will cause damage to the motor of your angle grinder. This can happen if your angle grinder is subjected to heavy duty use for prolonged periods of use. Do not in any circumstances, attempt to exert too much pressure on your angle grinder to speed up your work.
The abrasive discs operate more efficiently when a light pressure is exerted, thus avoiding a drop in the speed of your angle grinder (see Tool care).
TOOL CARE
Keep guards, air vents and the motor housing as clear as possible of dust and dirt. Wipe with a clean cloth and blow through with a low-pressure
air supply. Excessive build-up of metal dust can cause tracking of electrical current from the internal parts to exposed metal parts. Do not overload
your angle grinder. Overloading causes a reduction in speed and efficiency, causing your angle grinder to become too hot. If this happens, operate
your angle grinder under no load for one or two minutes until it has cooled to normal operating temperature. Switching your angle grinder off
under load will reduce the life of the switch.
CLEANING
Use only mild soap and a slightly damp cloth to clean your angle grinder. Many household cleaners contain chemicals which could seriously
damage the plastic. Also, do not use petrol, turpentine, lacquer or paint thinners or similar products. Never let any liquid get inside the tool and
never immerse any part of the tool into liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment (other than those listed in this manual)
should be performed by authorized service centers or other qualified service personnel, always using identical replacement parts.
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be disposed of with normal household waste.
Should you find one day that your Black & Decker product needs replacement, or if it is of no further use to you, do not dispose of it with
household waste. Make this product available for separate collection.
Separate collection of used products and packaging allows materials to be recycled and used again. Re-use of recycled materials helps
prevent environmental pollution and reduces the demand for raw materials. Local regulations may provide for separate collection of elec-
trical products from the household, at municipal waste sites or by the retailer when you purchase a new product.
SERVICE INFORMATION
Black & Decker offers a full network of company-owned and authorized service locations. All Black & Decker Service Centers are staffed with
trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory
replacement parts, contact the Black & Decker location nearest you.
14