Eclipse AVN4400 Manual Del Propietário página 4

Read the following prior
to using this device
• Wiring and installing this main unit requires expertise and experience. Professional
installation is recommended. Consult with your dealer or a professional installer.
Incorrect wiring may damage the main unit or interfere with safe vehicle operation.
• Use only the accessory parts as specified. Using other parts may cause damage to
the main unit or cause parts to dislodge and fall or fly off the main unit.
• Do not impede the air flow of the heat sink or vents of this main unit. Impeding the air
flow will cause the interior of the main unit to overheat, and fires may result.
• Connect as specified in the installation manual. If not connected correctly, fires or
accidents may result.
• Keep volume to a reasonable level so that you can hear sounds from outside the
vehicle, including warning sounds, voices, and sirens. Failure to do so may cause
an accident.
• Be careful that hands and fingers are not pinched when adjusting the tilting angle or
closing display. Injuries may result.
• Do not touch heat dissipating parts of the main unit as burns may result.
• Volume should be set at a moderate level to avoid hearing damage when the main
unit is powered on.
• Do not operate when the sound is not being emitted properly such as distortion.
• This main unit uses invisible laser light. Do not disassemble or alter this main unit. If
trouble occurs, contact the dealer where you bought the main unit.
Altering this main unit may cause exposure to laser emissions (worsening eyesight),
or result in accidents, fires or shocks.
• If the main unit is dropped or the cosmetics appear broken, turn off the power to the
main unit and contact your dealer. If used in this condition, fires or shocks may
result.
• Using the vehicle speed pulse signal, you can use the route guidance function even
in the locations where usually no guidance is given (example: in a tunnel). However,
the accuracy of the guidance is not guaranteed since the guidance is performed
using the information about road surface condition and vehicle speed.
• This device complies with part 15 of the FCC Rules. Operation is subject to the
condition that this device does not cause harmful interference.
FCC WARNING
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This Category II radio communication device complies with Industry Canada
Standard RSS-310.
4