GGP ITALY BLV 48 Li Manual De Instrucciones página 81

ASSEMBLE AS A BLOWER
See Figure 3
• Slide blower tube forward until the
notched areas on the blower housing
click into the slots on the tube.
• Insert the concentrator nozzle into the
regular nozzle to lock. (Concentrator
nozzle is used to increase air flow in tight
areas: flower beds,under decks, etc)
INSTALLING BAG WITH
SHOULDER HARNESS
See Figure 4.
• While standing in the operating position
adjust the length to fit the operator's size. Pull
the tab lengthen , pull the strap to shoten.
For complete charging instructions,
refer to the Operator's Manuals for your
battery pack and charger models.
NOTE To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the variable speed trigger
when carrying or transporting the tool.
TO INSTALL BATTERY PACK
See Figure 5.
• Place the battery pack in the blower.
Align raised rib on battery pack with
grooves in the blower's battery port.
• Make sure the latch on bottom of the
battery pack snaps in place and that
battery pack is secured in the blower
before beginning operation.
When placing battery pack in the
blower, be sure the raised ribs on the
battery pack align with the grooves in the
top of the blower. Make sure the battery is
fully seated, and it latches into place
properly. Improper installation of
the battery pack can cause damage
to internal components.
TO REMOVE BATTERY PACK
See Figure 5.
• Release the variable speed
trigger to stop the blower.
• Press and hold the button at the
bottom of the battery pack.
• Remove battery pack from the blower
STARTING/STOPPING THE
BLOWER/MULCHER
See Figures 6.
1. Press the On/Off (
you will hear beeping sounds, and the
blower will turn on in low speed.
) Switch and
2. Roll the variable speed dial forward to
increase speed from 110km/h to 210km/h.
3. Press the low/high switch (
the speed options from 130km/h to 280km/h.
4. To Turn off, press the on/off switch (
NOTE TURBO-MULCH by pressing
the "LOW HIGH button, with the variable
speed dial set to high speed.
HOLDING THE BLOWER/MULCHER
See Figures 7
Before operating the unit, stand in the
operating position. Check for the following:
• Operator is wearing proper clothing,
such as boots, safety glasses or
goggles, ear/hearing protection, gloves,
long pants and a long sleeve shirt.
To avoid serious personal injury,
wear goggles or safety glasses at all times
when operating this unit. Wear a face
mask or dust mask in dusty locations.
STATUS
hall fault
protection
low-voltage
protection
Over load
protection
Battery jam
protection
5
) to increase
LED SOLVE
METHOD
Green light Off the trigger
off red light and restart it
on; flash 7
times; each
time keep
1hz interval:
3s; keep 60s
buzzer alarm
Green light off Off the trigger
red light on; and restart it or
flash 5 times; Charging the
each time keep battery
1hz interval: 3s;
keep 60s
buzzer alarm
Green light off Off the trigger
red light on; and restart it
flash 4 times;
each time keep
1hz interval: 3s;
keep 60s
buzzer alarm
Green/Red light
Resetting the
off; Unit stop blower vac by
running removing the
battery for 5
seconds
).