Troubleshooting - Tanita SC-240 Manual De Instrucciones

- Please check the following before asking for repair.
Symptom
How to
measure
The measured weight is
not stable.
Nothing is displayed even
after turning on the power.
Display
part
is displayed.
Note
• In the case that an error is displayed other than the above, turn off the power once, and then
measure again.
If the same error is displayed repeatedly, contact our customer service center.
Impedance
measurement error
Zero point error

Troubleshooting

Please check
• Measure with bare feet.
• When the soles of your feet are dry,
drop water for about 0.5 ml with the
attached dropper on the electrodes before
measurement.
• Check the input information.
• Turn off the power, and remove the items
on the platform and turn on the power
again, and then redo the measurement.
• Is it installed at a place with vibrations?
• Is the platform inclined?
e Keep the platform horizontal.
• Is anything caught in the gaps of the
platform?
e Remove anything caught in the gaps.
• Check that the power supply is connected
correctly.
• The weight to measure exceeds the
measurement range.
17