Adjusting The Footrest - Peg-Perego pliko p3 compact Instrucciones De Uso

chassis, pull the two levers on the handlebars upwards
(Fig.b);
2• at the same time, lift the chassis and it will open
automatically (Fig.c). To make sure that the stroller is
correctly open, check the two side hooks (Fig.d).
3• ASSEMBLING: to mount the front wheels, firstly check
that the washer is present, as shown in the figure, then
lower lever A and slip wheel B on until it clicks into place.
4• To mount the rear wheels connected by the brake
cable, place them with the brake facing externally (fig_a).
WARNING: ensure the hooks have clicked into place, as
in figure b.
5• Finally, hook the central element of the brake cable onto
the chassis, ensuring it clicks into place, as in the figure.
6• BASKET: to mount the basket, slip the loops over
the front hooks A and rear hooks B and C. The figure
shows the attached basket.
7• CUP HOLDER :It can be applied on the 4 knobs on the
chassis. Two are on the left or right side of the handle
and two on the sides of the pushchair's chassis, at the
height of the bumper, on the right or left . To apply the
cup holder, attach it and press until it clicks into place
(Fig. a).
ADJUSTING THE HANDLEBARS: The height of the two
handlebars can be adjusted to 3 positions. For the
higher position, press the button while pulling the
handlebars upwards. To lower it, do the opposite (Fig.b).
8• BRAKE: to set the brakes on the stroller, lower the
levers on the rear wheels with your foot (Fig.a). To
release the brakes, lift the lever.
Always set the brakes when the stroller is not moving.
SWIVEL WHEELS: to swivel the front wheels lower the
levers as shown in arrow 1 (Fig.b).
WHEELS IN STATIONARY POSITION: To make them
stationary, push the lever in the opposite direction, as
indicated by arrow 2.
9• HOOD: to mount the hood, fasten the attachments
which are situated on the sides of the hood onto
those on the chassis, pushing outwards until the hood
clicks into place (Fig.a); fasten it onto the inside of the
armrest (Fig.b),
10• and onto the backrest of the stroller (Fig.c). The hood
has a window enabling you to observe your child, a
large and practical pocket (Fig.d) and a cord which
games can be hung on (Fig.e).
To remove the hood: unhook the hood's side
attachments from the chassis by pulling inwards,
unbutton it from the inside of the armrest and from
the backrest of the stroller.
11• You can detach the back part of the fabric by unzipping it
and use the hood also as a sun canopy (Fig.a). To reattach
the back part of the fabric, close the zipper (Fig.b).
12• By lowering the stroller backrest, the rear hood
extends and through the double zipper a window can
be created to allow more air to circulate and watch the
child when sleeping.
13• COVER: for complete Pliko P3 Compact:
To put the apron on the pushchair, do up the buttons
on both sides and under the footrest (Fig. a). Pull the
cover upwards so that it covers the bumper bar (Fig.
b). Some models have a muff as well, so putting on
the cover may be a little different (Fig. c).
1 4• COVER: Pliko P3 Compact On Track :
Use the XL Carrycot apron because it fits onto the
Pliko P3 Compact standard car seat and onto the
lie-flat car seat. Please read the instructions for
information on how to put it on the XL Carrycot.
To put the apron on the pushchair, widen it out so
that it covers the child's legs (Fig. a).
Pull it across the bumper bar and do up the buttons in
the front (Fig. b).
Slip the footrest under the cover, stick the Velcro
strips together and do up the buttons (Fig. c) on the
lower part of the apron.
15• RAINCOVER (only for the CLASSIC PLIKO P3 COMPACT
model):
to fit the rain canopy, extend it over the stroller and
snap fit the buttons on both sides of the hood (Fig.a).
Fasten the elastic loops including the chassis in the
lower part of the stroller (Fig.b).
• Do not use the rain canopy indoors and always make
sure that the child is not too hot.
• Do not place the rain canopy near heat sources and
pay attention to cigarettes.
• Make sure that the rain canopy does not interfere with
any moving mechanism of the stroller.
• Always remove the rain canopy before folding up the
stroller.
• Wash with a sponge and soapy water. Do not use
detergents.
16• 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
17• To tighten the waist strap, pull on both sides in the direction
of the arrow (Fig.a). To loosen it do the opposite. The waist
strap can be tightened as far as the safety lock (Fig_b).
18• To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
19• ADJUSTING THE FOOTREST: the footrest can be adjusted
to three positions. To lower the footrest, pull the two
side levers downwards while lowering the footrest. To
lift the footrest, pull it upwards until it clicks into place.
2 0• ADJUSTING THE BACKREST: the backrest reclines to
four different positions. To lower the backrest, lift the
handle while lowering the backrest, locking it in the
desired position. To raise it, pull the backrest upwards.
2 1• FRONT BAR: to fasten the front bar, slip both ends of
the front bar into the armrests until it clicks into place.
2 2• The front bar can be opened to one side only to allow
the child to get in and out of the stroller easier when he
or she is older. To open the front bar, press the button
under the armrest while pulling out the front bar (Fig.a).
To remove the front bar, press the two buttons under
the armrests while pulling out the front bar (Fig.b).
23• Only for the complete Pliko P3 Compact and On Track
Pliko P3 Compact models:
when you remove the bumper bar insert the two tops
in order to close the armrests of the chassis.
2 4• REAR LEDGE: the rear ledge helps the mother
overcome small bumps and can also be used to carry a
second child (fig_a).
- 21 -