Hazards - Astralpool PROHEAT II Serie Manual De Instrucciones

PROHEAT II SERIES · HEAT PUMP AIR/WATER SYSTEM
2.4.

HAZARDS

This section identifies the residual risks identified through a risk assessment.
To reduce health hazards and avoid dangerous situations, pay attention to the safety
instructions listed below:
DANGER OF INJURY BY LIQUID ACCUMULATIONS:
Danger of slippage by liquid accumulation.
•
•
DANGER OF INJURY OR DEATH BY ELECTRICAL SHOCK:
In the event of direct contact with live parts, there is a risk of death from
electric shock. Damage to the insulation or damage to various components
can lead to death.
•
•
•
DANGER OF INJURY BY MOVING PARTS: FANS
Rotating parts of the fans can cause serious injuries.
DANGER OF INJURY BY SHARP EDEGES AND SHARP CORNERS:
Danger of injury with sharp edges and sharp corners.
Sharp edges and sharp corners on components housing parts can cause
cuts on the skin.
•
•
© FLUIDRA 2019 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
Collect liquids accumulation with the proper means.
Wear non-slip safety footwear.
Place warning and signaling signs in the area where liquid
accumulation may occur.
Only qualified people may work on the electrical installation.
If you notice any damage to the insulation, disconnect power
supply and proceed to repair any damage.
Before starting any work on the electrical installation, follow the
following rules:
 Remove power supply.
 Safeguard against reconnection.
 Check coltage absence.
 Grounding and short-circuiting
Protect the work area.
• Do not put your hands into the fan rotor or maintenance it
during operation.
• Do not open the machine's panels during operation.
Make sure that the fan rotor is not accessible during
•
operation.
• Pay attention to the fan stop interval before opening the
machine's panels.
Before opening the fan, check that it is stationary.
•
When working in the vicinity of sharp edges or sharp corners,
proceed with coution.
Wear protective gloves.
ENGLISH
Pag: 10