THERMEx HARWICH Instrucciones De Montaje página 48

48
THERMEX HARWICH
10
x2
Measure the placement of the bracket and
mark the position of the holes on the wall.
NOTE: The bracket must be positioned so that
it matches the holes in the duct.
13
Set the duct down into the well on the hood.
INSTALLATION OF ISLAND MODEL
The island model is mounted in the following way:
1
Push the panel with the hood's electronics into
place over the screws found on the top of the
hood.
11
x2
x2
Drill the holes and install rawl plugs intended
for the material into which they are installed.
14
x2
Pull up the top part of the duct and secure it to
the bracket with the screws supplied.
2
Secure the panel by tightening the three
screws.
M 527428568201092016
12
x2
Mount the bracket on the wall.
3
Mount the stand on the hood with four screws.
x4