Hkoenig NV700 Manual De Utilización página 14

steam trigger (15) is pressed. The faster you press it, the more steam is emitted.
However, this is at the expense of the temperature.
1. Attach the attachment you want to the device (see the "Mounting the Accessories"
chapter).
2. Insert the mains plug into a properly installed mains socket that is easily accessible.
Steam starts to be generated and the control lamp (17) lights up.
3. Wait until the control lamp goes out. Operating temperature has then been reached and
you can start steam-cleaning: Press the steam trigger (15) and move the attachment
over the surface to be cleaned as you do so.
If the steam trigger cannot be pressed, the safeguard (13) has probably been
activated. Push in the securing pin to release the safeguard.
4. If the control lamp lights up, the temperature has dropped. Let go of the steam trigger
and only press it again once the control lamp has gone out.
5. If the water reservoir is empty, steam will no longer be produced. If you want to top up
the water in the reservoir (see the "Filling the Water Reservoir" chapter) or want to stop
working, pull the mains plug out of the plug socket and allow the device to cool down
completely. Keep pressing the steam trigger if necessary until no more steam emerges
from the device. The water reservoir can then be opened.
6. Empty and clean the water reservoir each time after you use the device (see below)
to prevent deposits in the reservoir and thus damage to the device!