Adjusting The Strike Plate; Adjusting The Cync Latch - Leer LATITUDE Instrucciones De Instalación Y Manual Del Usuario

LATITUDE INSTALLATION INSTRUCTIONS

9. ADJUSTING THE STRIKE PLATE

1
Latch Guide
Set-screw
3
Striker
Adjustment
Screw
Note:
Striker may need
Adjustment after seals
Have compressed
periodically check.
Latch Guide
Set-screw
Latch
Guide
Set-screw

10. ADJUSTING THE CYNC LATCH

To adjust the CYNC latching system, adjust
one side at a time. Make sure the other side is
tightened down.
1. Loosen both set screws on one side.
2. Slide CYNC latching system catch to touch
striker plate. If the cover closes too hard, add
a wrench width of clearance between the slide
CYNC latching system catch and the touch
striker plate or adjust to desired closing force.
3. Tighten latch guide set-screw
4. Pull inwards on inner latch both sides, until
latch has tension.
5. Tighten inner latch set screw.
*Repeat for the opposite side.
2
Touch
Contact
Location
LATITUDE WITH LEER'S EXCLUSIVE
4
5
Patented and Patent Pending see LEER.com • 203984 REV J
Inner
Latch
Set-screw
7