JENN-AIR JJW8127 Guia Del Usuario página 10

C
& C
ARE
S -C O
ELF LEAN
The self-clean cycle uses above normal cook-
ing temperatures to automatically clean the
entire oven interior. While this occurs, a
device in the oven vent helps consume normal
amounts of smoke. The oven is vented
through an opening under the control panel.
It is normal for flare-ups, smoking or flaming
to occur during cleaning if the oven is heavily
soiled.
It is better to clean the oven regularly rather
than to wait until there is a heavy build-up of
soil in the oven.
During the cleaning process, the kitchen should
be well ventilated to help eliminate normal
odors associated with cleaning.
Do not use commercial oven cleaners on
the self-clean oven finish or around any part of
the oven as they will damage the finish or
parts.
B S -C
EFORE ELF LEANING
Turn off the oven light before cleaning as the
light may burn out during the clean cycle.
Remove broiler pan, all pans and the oven
racks from the oven. The oven racks will
discolor and may not slide easily after a
self-clean cycle.
Clean oven frame, door frame (area outside
the door gasket) and around the opening in
the door gasket with a non-abrasive cleaning
agent such as Bon Ami* or detergent and
water. These areas are not exposed to clean-
ing temperatures and should be cleaned to
prevent soil from baking on during the clean
cycle.
To prevent dam-
age, do not clean
or rub the gasket
around the oven
door. The gasket is
designed to seal in
heat during the clean cycle.
Wipe up excess grease or spillovers from the
* Brand names are registered trademarks of the respective manufacturers.
LEANING
oven bottom to prevent excessive smoking,
VEN
flare-ups or flaming during the clean cycle. For
ease of cleaning, the heating element can be
lifted slightly (1 inch).
Wipe up sugary spillovers and acidic spillovers
such as lemon juice, tomato sauce or milk-
based sauces. Porcelain enamel is acid resis-
tant, not acid proof. The porcelain finish
may discolor if acidic spills are not wiped
up prior to a self-clean cycle.
S
ETTING THE
FOR A
1. Close the oven door.
2. Press Clean pad.
• "- - : - -" will light in the display.
• CLEAN will flash in the display. LOCK
indicator word will appear.
• Door cannot be opened when LOCK
is displayed.
• If door is not closed or locked, beeps
will sound and "door" will flash in the
display.
3. Press More+ or Less- pad to select
clean time or change clean time.
• Oven is preset to clean for 3 hours. Or,
• Select 2 hours for light soil up to 4
hours for heavy soil.
4. When the oven turns on the clean sym-
bol will light in the display.
5. About one hour after the clean cycle
ends, the LOCK indicator word will turn
off. The oven door can be opened.
C
ONTROLS
S -C C
ELF LEAN YCLE
CLEAN SYMBOL
LOCK IS STILL ENGAGED.
DOOR CANNOT BE
OPENED UNTIL LOCK IS
NO LONGER DISPLAYED.
9
A S -C
FTER ELF LEANING
About one hour after the end of the clean
cycle, the LOCK indicator word will turn
off. At this point, the door can be opened.
Some soil may leave a light gray, powdery
ash which can be removed with a damp
cloth. If soil remains, it indicates that the
clean cycle was not long enough. The soil will
be removed during the next clean cycle.
If the oven racks were left in the oven and do
not slide smoothly after a clean cycle, wipe
racks and embossed rack supports with a
small amount of vegetable oil to restore
ease of movement.
A white discoloration may appear after clean-
ing if acidic or sugary foods were not wiped
up before the clean cycle. This discoloration
is normal and will NOT affect performance.
TO DELAY THE START OF A
CLEAN CYCLE:
1 - 3. Follow previous steps 1-3.
4. Press Stop Time pad.
a. Press More+ or Less- pad to select
the time of day you wish the oven to
turn off.
b. Press Clock pad and time of day
will reappear in display.
c. DELAY CLEAN will remain in display
to show the oven is set for delayed
clean operation.
5. When the oven turns on the clean symbol
will light in the display.
6. About one hour after the clean cycle
ends, the LOCK indicator word will turn
off. The oven door can be opened.
TO CANCEL A CLEAN CYCLE:
1. Press CANCEL pad.
2. If LOCK is NOT displayed, open oven
door.
If LOCK is displayed, allow oven to cool
about one hour then open oven door.