To Avoid Malfunctions - Panasonic VW-CLT2 Instrucciones De Funcionamiento

To Avoid Malfunctions

∫ About the Handling of the 3D Conversion
Lens
≥ Sand or dust will cause malfunctions in the 3D
Conversion Lens. Be careful not to allow sand or
dust to get inside the 3D Conversion Lens when
using at the beach or similar.
≥ The 3D Conversion Lens is not waterproof. Wipe
with a dry cloth if any water gets on it.
Contact the retailer or the service center when it
does not operate properly.
≥ Image may be affected when the surface of the
protective panel is contaminated by water, oil,
fingerprints, etc. Wipe the surface of the protective
panel gently with a dry soft cloth before and after the
recording.
≥ Remove the 3D Conversion Lens from the video
camera and place it in the lens storage bag when
carrying.
∫ About Condensation (When the 3D
Conversion Lens is Fogged Up)
≥ Condensation occurs when there is a difference in the
temperature or humidity as in the following cases. Be
careful since it may cause contamination, mold, or
malfunction of the 3D Conversion Lens.
j When it is carried indoors from a cold outdoor
environment
j When carried out from a cool, air-conditioned car,
etc.
j When cool wind from an air conditioner is directly
blown onto the lens
j In an area with high humidity
≥ To prevent condensation, place in a plastic bag and
allow it to warm up to the ambient temperature. If any
condensation occurs, leave it as it is for
approximately 1 hour. Condensation will disappear on
its own once it is warmed up to the ambient
temperature.
English
3
(ENG)VQT4A75