Adjusting The Height To Make The Unit Horizontal; Fit The Dust Cover; Installation - Technics SL-1500C Instrucciones De Funcionamiento

Connections and installation
Install the unit on a horizontal surface
protected from vibrations.
Keep this unit as far as possible from speakers.
 
Adjusting the height to make the
unit horizontal
Increases
the height
Raise the main unit to turn the insulators and
adjust the height.
 Clockwise: Reduces the height.
 Anti-clockwise: Increases the height.
Attention
 Do not turn the insulators too far.
Doing so may cause them to come off or
damage them.

Fit the dust cover

1
Hold the dust cover with both
hands and insert it into the dust
cover fitting parts (  9) on the
player.
 To remove the dust cover, keep it open
and lift it straight above.
Attention
 Return the tone arm to the arm rest and fix
it with the arm clamp before you attach or
detach the dust cover.
 Remove the dust cover while playing.
 When inserting the dust cover, prevent the tip
of the hinges from hitting and damaging the
main unit.
14
(14)
English

Installation

 
 Before you move the unit, turn the unit off,
pull out the power plug and disconnect all
connected devices.
 Ensure the unit is not exposed to direct
sunlight, dust, humidity, and heat from a
heating appliance.
 This unit may pick up interference from a
radio if there is one nearby.
Keep the unit as far as possible from a radio.
 Do not install the unit on a heat source.
 Avoid a place with large temperature variations.
 Avoid a place with frequent condensation.
Reduces
 Avoid an unstable place.
the height
 Do not put an object on the unit.
 Do not install the unit in a confined space
such as a book shelf.
 Install the unit at a position well away from
walls or other devices to ensure effective
heat radiation from the inside of the unit.
 Make sure the installation location is
sufficiently strong to withstand the total
weight of the unit and system.(  23)
 Note that the unit may be damaged by
cigarette smoke or moisture from an
ultrasonic humidifier.
 
Think of taking out a cold bottle from a
refrigerator. If you leave it in a room for a while,
dewdrops will form on the bottle surface.
This phenomenon is called "condensation".
 Conditions causing condensation
 Rapid temperature change (caused by
 High humidity in a room with much steam,
 Rainy season
 Condensation may damage the unit. If it
has occurred, turn the unit off and leave it
until it adapts to the ambient temperature
(approximately 2 to 3 hours).
(continued)
Notes for installation
Condensation
moving from a warm place to a cold place or
vice versa, rapid cooling or heating, or direct
exposure to cooled air)
etc.