Tabla de contenido
2) Set parameters. See Table 4-43.
Parameter
Preset
Name
Duration
Filter target
3) Draw a rule. Left click mouse to draw a zone, until you draw a rectangle, you can right click mouse.
4) Click OK to complete the rule setting.
Step 3 Click
Step 4 Click Apply to complete the setup.
4.7.2.4.6 Parking
When the detection target stays in the monitoring area for more than the set duration, the system performs alarm
linkage action.
Step 1 In the Type drop-down list, select Parking.
The interface is shown as below. See Figure 4-145.
Figure 4-144
Description
Select a preset you want to use IVS. Input
customized rule name
Set the minimum time that the object stays until the alarm is triggered.
Click
to filter the target. Check the blue wireframe and adjust the size of the area
with the mouse.
Each rule can set 2 target filters (maximum size and minimum size), that is, when the
passing target is smaller than the minimum target or larger than the maximum target, no
alarm will be generated. The maximum size should not be smaller than the minimum size.
, you can refer to "4.7.2.4.1 Tripwire" to set other parameters.
Table 4-43
235
User's Manual
Tabla de contenido
