GUTMANN Hermano Instrucciones De Montaje página 8

en
3. In order to achieve optimal exhaust
capacity, the hood must be situated in the
center of the cooking area. Plot the middle of
the hood on the ceiling using a plumb line.
Then take the position of the attachment holes
from the hood and transfer them to the ceiling.
4. Create the attachment holes on the ceiling
(hole diameter 10mm) and insert the screw
anchors provided. Now screw the machine
screws into the screw anchors and allow them
to protrude by approximately 20mm. Attach
the hood to the machine screws using
washers and nuts. Make sure that the
operating panel is on the operating side. Po-
sition the hood and tighten the nuts.
5. Cut the exhaust hose to the necessary
length and feed it into the hood via the gap in
the roof, so that it protrudes from under the
hood by approximately 100mm. Now create
the electrical connection to the power supply.
Place the exhaust hose onto the connection
posts of the module and connect it using hose
clamps.
6. Now place the filter intake with glass pane
and module back into the hood. Installation
of the filter intake with glass pane and module
takes place in the reverse order of the
sequence described in 1 and 2.
7. The exhaust hose must always be laid out
in a manner in which it is not bent. Be certain
to disconnect the plug from the outlet before
conducting electrical work on the exhaust
hood.
8. Now conduct a function test.