Tabla de contenido
ENGLISH
How to assemble
Dust Bag models
CAUTION
Assemble vacuum cleaner FULLY before using.
• Remove all parts from carton and identify each
item shown. Make sure all parts are located
before disposing of packing materials.
Assembly Packet
• The packet contains two 2-part bolts, two
screws, upper and lower cord hooks, an extra
belt and a dual-zipper pull.
Assembly
1. Slide the upper handle and the lower handle
together so the handle bolt holes are positioned
as shown in the detail drawing. Insert a 2-part
bolt in the center of the handle and tighten. Hold
the assembled handle so it curves away from the
cleaner. Place the lower handle into the handle
socket at the rear of the cleaner. Align the holes,
insert the other 2-part bolt and tighten.
2. Pull the spring on the electrical cord upward
toward the top of the handle. Insert the lower half
of the spring into the upper cord hook as shown.
Snap the hook into the upper handle (Fig. 4).
3. Insert the power cord into the lower cord hook.
Snap into lower handle per figure (4). Pull on the
cord to tighten, but leave enough slack near the
base so the cord is not strained when the handle
is lowered. Wrap the cord around the two cord
hooks and fasten the plug to prevent unwinding. A
downward twist of the cord hook frees the cord for
quick removal.
Hold outer bag with zipper away from the handle.
Align holes in outer bag flange and base. Fasten
with the two screws. Loop the bag spring onto the
bag support hook located at the back of the upper
handle section.
Powr-Flite.com
9
Tabla de contenido
