Tabla de contenido
ENGLISH
How to assemble
Dirt Cup models
CAUTION
Assemble vacuum cleaner FULLY before using.
• Remove all parts from carton and identify each
item shown. Make sure all parts are located
before disposing of packing materials.
Assembly Packet
• The assembly pack is with the owner's guide. The
packet contains two 2-part bolts, two screws, an
extra belt, upper cord hook, lower cord hook and a
cord clamp and screw.
Assembly
1. Align the screw holes in the bellows adapter with
the back of the base and fasten with two screws.
2. Raise the dirt cup support. Push the lower handle
(largest end down A) through the tube (B) of the
dirt cup support and into the handle socket (C) at
the back of the cleaner. Align the holes, insert a
2-part bolt and tighten.
Hold the upper handle (D) so it curves away from
the cleaner. Push it down over the lower handle
and secure with the other 2-part bolt.
3. Secure the electrical cord to the dirt cup support
with the cord clamp and screw. Place the clamp
over the electrical cord and screw to the tab below
the left latch when facing the vacuum.
4. Pull the spring on the electrical cord up toward the
top of the handle. Insert the lower half of the spring
into the upper cord hook (Fig. 5).
6. Snap the hook into the upper handle.
7. Insert the power cord into the lower cord hook.
Snap into lower handle. Pull on the cord to tighten
but leave enough slack near the base so the cord
is not strained when the handle is lowered. Wrap
the cord around the two cord hooks and fasten the
plug to prevent unwinding.
8. Slip the ring at the top of the cloth bag over the
support hook on the back of the top cord hook.
Powr-Flite.com
7
Tabla de contenido
