Get Started; Bridge-Mono Mode - Harman Crown XLS Serie Operación Manual

Get Started

Stereo Bypass Mode
This is the default mode the amplifier is set to from the factory. The amplifier is
configured for stereo mode with the PureBand™ Crossover System Bypassed.
1. Connect Left/Right signal source to Channel 1 and Channel 2 using either
the XLR, ¼ Inch, or RCA connectors.
2. Connect a speaker to each channel output using Speakon
or bare wire.

Bridge-Mono Mode

Bridge-Mono Mode delivers the power of both amp channels into a single 8 or
4 ohm load.
Before you get started ensure that you:
1. Connect signal source to Channel 1 only using either the XLR, ¼ Inch, or
RCA connectors.
2. Connect the speaker as shown.
a. If using the binding post outputs, connect the positive terminal of the
speaker to the positive terminal of Channel 1 and the negative terminal of
the speaker to the positive terminal of Channel 2.
b. If using a Speakon connector, connect the positive terminal of the speaker to 1+ and the negative terminal to 2+.
®
Plug the connector into the Channel 1 output only.
Follow these quick steps to configure the amplifier for "Bridge Mode":
1. Hold the "Mode/Menu" button down for 3 sec until the LCD screen displays "Amp Mode <More>".
2. Press the "Mode/Menu" button to begin configuring the Amp Mode.
3. Press the "Next" button until the LCD screen reads "Mode: Bridge".
4. Press the "Mode/Menu" button to confirm your selection.
5. Now press the "Next" button until the LCD screen displays "Bypass". Press the "Mode/Menu" button to confirm your selection. The LCD screen should now read
"Bridge Bypass".
Crossover Mode
When using the "Crossover Mode", the amplifier is configured to use a LowPass
Filter on Channel 1 and a HighPass Filter on Channel 2.
Before you get started ensure that you:
1. Connect signal source to Channel 1 only using either the XLR, ¼ Inch, or
RCA connectors.
2. Connect a speaker to each channel output using Speakon
or bare wire.
Follow these quick steps to configure the amplifier for "Crossover Mode":
1. Hold the "Mode/Menu" button down for 3 sec until the LCD screen displays
"Amp Mode <More>".
2. Press the "Mode/Menu" button to begin configuring the Amp Mode.
3. Press the "Next" button until the LCD screen displays "Input Y". Now press the "Mode/Menu" button to confirm.
4. Now press the "Next" button until the LCD screen displays "XOVER" and press the "Mode/Menu" button to confirm.
5. Now use the "Previous" or "Next" button to select your desired crossover point.
6. Once you have selected your crossover point, press the "Mode/Menu" button to confirm your selection. The LCD screen should now read "Input Y XOVER".
page 4
Stereo ByPass Mode
, Banana Plugs,
®
Bridge-Mono Mode
Crossover Mode
, Banana Plugs,
®
XLS Series Power Amplifiers
Operation Manual