Zuzi UV-VIS 4481/1 Manual De Instrucciones página 35

Introduction of function keys on the Parameter Setting-Curve of Multi-point Calibration interface:
[BACK] Return to the Parameter Setting page of Quantitative Measurement. (The riginal settings will
be lost.)
[Display Data] Return to the Parameter Setting for
Multi-point Calibration. (The original settings will not
be lost.)
[Test] After the calibration of curve, the system starts
testing. The display will jump to Multi point Calibration
page.
[SAVE] Save the current coordinate curve which has
been calibrated and the equation files
[PRINT] Print the current coordinate curve which has
been calibrated.
Introduction of function keys on the multi point Calibration interface:
[R Position] Press this key, the cell holder returns to the default position R.
[ ] and [ ] Cell holder selection key. Press left arrow to return to the former position and press right
arrow to go to next position.
[AUTO ZERO] Press this key to adjust zero automati-
cally.
[START] Start testing the concentration of solution in
current sample cell.
[PRINT] Print the concentration information of the
test which is just finished.
[HOME] Go back to the first page.
[PRE]/[NEXT] Use the keys to go to the previous or
next page.
[END] Go to the last page.
File List
Press [SAVE] and [LOAD] on the Parameter Setting page, or press [SAVE] on the Multi point
Calibration (Parameter Setting) curve interface, the display will jump to File List page.
A maximum of 10 curves can be stored in the instrument which doesn't share the same the file list with
other functions. Select the location of a file first, then can perform save, read, rename or delete operations.
The introduction of function keys on File List page:
[SAVE] First, select the location where the file is to be saved, press [SAVE], and a numeric keypad will
pop up. Enter a name for the file, press [ENTER] to confirm, and the current curve information will be
saved. The file name must contain less than 10 characters. If a selected serial number already has a file,
the new file will overwrite it.
[LOAD] First, select the location where the file is saved, press [LOAD], the page will jump to Curve
Display, and the curve information which has been
read will display.
[Rename] First, select the location where the file is
saved, press [Rename], and a numeric keypad will
pop up. Key in a new file name, press [ENTER] to con-
firm, and the file will have a new name.
[Delete] First, select the location where the file is
saved, press [Delete], and the selected file will be dele-
ted.
[Back] Return to the Parameter Setting page of
Quantitative Measurement.
Manual de instrucciones 54481001 Pág. 35 Version 1 December 2015