Premier ED-5054PL Manual De Instrucciones página 10

13. When using electrical appliances, basic safety precautions should always be followed including the following.
14. Close supervision is necessary when any appliance is used by or near children.
15. To reduce the risk of injury,never place cutterd-assenbly blades on base without jar properly attached.
16. Always operate blender with cover in place.
17. The use of attachments,including canning jars,not recommended by the manufacturer may cause a risk of injury to
persons.
18. When blending hot liquids,remove center piece of two-piece cover.
19. Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons or damage to
the blender(another trade name may be used). A scraper may be used but must be used only when the blender is
not running(does not apply to an acceptable scraper integral with the appliance).
20. Blades are sharp.Handle carefully.
21. Any other servicing should be performed by anthorized service representative.
22. This appliance has a polarized plug(one blade is wider than the other).To reduce the risk of electric shock,this plug
will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet,reverse the plug.If it still does not
fit,contact a qualified electrician.Do not modify the plug in any way.
23. This product is intended for indoor,non-commercial,non-industrial,household use only.Do not use outdoors.
SAVE THESE INSTRUCTIONS FOR FUTURE
Learning About Your Blender
1. Filler-Cap
2. Lid
3. Jar (6 cup/1.5 Litre)
4. Blade Assembly
(also called cutting blades) / skirt
5. Base
6. Control Panel
7. Bottom Cover
After unpacking the blender, wash everything except the blender base in warm, soapy water. Dry
thoroughly. Do Not place in dishwasher. Wipe the blender base with a damp cloth or sponge. Do Not
immerse the base in water. Care should be taken when handling the blades, as they are very sharp.
How to Assemble and Use
Important: Your blender jar and cutting blades are subject to wear during normal use. Always inspect
cutting blades for broken, cracked or loose blades. If jar or cutting blades are damaged, Do Not use.
Make sure blender is unplugged. Place blender base on clean, dry surface to keep foreign particles

from being pulled up into motor during operation.
Before inserting blade assembly/skirt, be sure that the gasket is seated around blade base.

In order to insert blade assembly/skirt, tilt it slightly and entre with the serrated blade that curves up.

Move as needed to clear the remaining blades. To remove, just reverse the process; lower slightly
and in the direction of the serrated blade. Tilt up and the other blades will clear the jar bottom
REFERENCE
P-3