Accessmatic accesloop500 Manual De Usuario página 23

accesloop
LED indicator
Status
Power up
Sensitivity indicator
Preparation for data collection
Indicator for connection fault of loop
Beginning of detection
Vehicle presence in loop of channel 1
No vehicle in both
Vehicle presence in loop of channel 2
Vehicle precense in both
Loop installation
All induction should be in a roadway by cutting slots with a masonry cutting disc or similar device 45 ° crosscuts should be made across
the loop corners to reduce the lchange of damage that can be caused to the loop and the right angle corners.
Nominal slotwidth: 4mm
Nominal slotdepth: 30 - 50mm
A slot must be cut from the loop circunference at one corner of the loop, reading to the roadway edge to accommodate the feeder.
The loopsare sealed using a quick - setblack epoxy compound or hot bitumen mastic to blend with the roadway surface.
www.accessmatic.com
500 5242
Channel 1 green
channels 1 and 2 light simultaneously once,
indicating sensitivity indication begins.
Channels 1 and 2 light sequentially ( ashing frequency
Channels 1 and 2 light simultaneously
Short circuit of loop or frequency <15 kHz, indicator
of corresponding channel ashes (frequency = 5 Hz). Frequency operation
> 120 kHz, indicator of corresponding channel lights.
Light
Extinguish
Extinguish
Light
Channel 2 green
= 1Hz), sensitivity = blink times.
for 2 seconds extinguish.
Extinguish
Se apaga
Extinguish
Extinguish
Light
Opening your life
Red
Light
Light
Light
Light
Enciende 1s después de
energizar, se apaga indicando
inicio de detección
Light
Light
Light
Light
8