Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Changing the magazine (optional accessory)
013165
A magazine with different length is available as optional
accessory.
To change the magazine, loosen the bolt and remove
the magazine. Then install the new magazine. And
fasten the bolt on the magazine.
OPERATION
WARNING:
Do not touch around the exhaust vent. The
•
surface will be very hot during or after an
operation. Touching around the exhaust vent may
cause burns or injuries.
CAUTION:
Make sure all safety systems are in working order
•
before operation.
013160
1.
To drive a nail, place the contact element against
the workpiece.
The fan motor is activated, fuel gas is injected into
combustion chamber and mixed with air by the fan.
1. Bolt
1
1
013161
2.
Hold the contact element pressing firmly and pull
the trigger.
Fuel gas is combusted and the nail is driven.
3.
Further driving can be initiated only after both the
contact element and the trigger are released.
Nail-driving of concrete
WARNING:
Use hardened nails only for concrete.
•
Using other purposed nails may cause serious
injuries. Do not nail directly on the concrete.
Failure to do so may cause concrete fragments to
fly off or nails to strike back, causing serious
injuries.
When driving nails, hold the tool so that it stands
•
upright to the driving surface.
Slanted nail-driving may cause concrete fragments
to fly off or nails to strike back, causing serious
injuries.
Do not use the tool on the surface that objects
•
hang from, such as area where hangers for sewer
pipe, dust pipe etc. are set up
Choose and use appropriate nails so that the
penetration amount into concrete ranges 15 mm (9/16")
- 20 mm (13/16").
1
2
010319
9
1. Trigger
1. Thin steel plate
2. Penetration
amount into
concrete
Tabla de contenido
