Starting Operation And Function Check; Adjustment Of The Brush Rollers; Function Check; Raise The Side Brushes - Alto FLOORTEC 380 M Instrucciones De Manejo

2.2.2 Fitting of the side
brushes
2.3 Starting Operation and

Function Check

2.3.1 Adjusting the side
brushes
NOTE!
All the brushes should be set so
that they contact the ground with
only slight pressure.
2.3.2 Adjustment of the
brush rollers
NOTE!
The setting must be the same on
both sides in order to ensure that
the brush roller is horizontal in
the sweeping machine.
2.3.3 Function check • Push the machine at normal
walking speed over the sur-
face to be cleaned:
The cleaning capacity is de-
pendent on the working speed
(number of revolutions of the
brush rollers).
The side brushes allow edges
and corners to be swept clean.
• Push the side brush from
below into the snap device
provided on the side brush
arm.
The push-type sweeping ma-
chine is set at the factory for
operation on smooth and level
floors.
• Move the side brushes into
working position by turning
the adjusting knob.
• To adjust the height of the
brushes, turn the adjusting
knobs to the left or right.
On uneven floors or in the event
of brush wear:
• Raise the latching height
indicator on the side of the
machine with two finger and
move to the desired position.
Downwards, i.e. with increasing
symbol bar thickness, increases
the brush pressure.
• Check the sweeping result
and then correct the brush
pressure, if necessary, as
described above.
When the machine is pulled
backwards, the side brushes
and brush rollers automatically
lift slightly from the floor. This
prevents the creation of unnec-
essary dust.
FLOORTEC 380 M
english
5