Operation With Detergent - Oleo-Mac PW 250 HC Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 45
The Manufacturer recommends the use of detergents which are at least 90% biodegradable.
Refer to the label on the detergent for instructions on how to use it.
• Fill the bottle (34) with the desired detergent.
• Regulate the detergent suction capacity in the following way:
- disconnect the rod (33) from the lance (32);
- the E tooth on the rod (33) must match with one of the numbers on the inside of the lance (32) (1: minimum
suction; 6: maximum suction);
- re-connect the rod (33) in the lance (32).
• Insert the bottle (34) in the foam lance (32).
• Put the main switch (1) to position "0" and connect up the lance (32) and the spray gun (18).
• Start up the high pressure again, by putting the main switch (1) to position "I" and operating its lever (23)
(suction and mixing will start automatically when water goes through).
• Release the cleaner gun lever (23) to stop the high pressure jet; the high pressure cleaner moves to the
by-pass operating mode and stops immediately.
• The cleaner will resume normal operation the as soon as the lever on the gun is pressed.
WARNING
• If you stop the high pressure jet and put the gun down, enable the locking handle (24). Step C in Fig. 5.
• Run the cleaner for a few minutes with cold water.
• Close the tap on the water supply off completely (or remove the suction pipe from the draft tank).
• Drain the water out of the cleaner by running it for a few seconds with the cleaner gun lever (23) pressed.
• Move the master switch (1) to "0"
• Take the plug out of the power socket.
• Eliminate any remaining pressure in the high pressure hose (26) by keeping the cleaner gun lever (23)
pressed down for a few seconds.
• Wait for the cleaner to cool down.
• Wind up the high pressure hose (26) with due care, making sure it is not bent; store it carefully, without
damaging it.
• Wind up the power cord (6) carefully its support (7).
• Store the high pressure cleaner in a clean, dry place. Make sure the power cord and the high pressure
hose are not damaged.
24

OPERATION WITH DETERGENT

STOPPING THE CLEANER – TOTAL STOP MODE
STOPPING
STORAGE
Tabla de contenido
loading

Este manual también es adecuado para:

Ip 2500 hs

Tabla de contenido