Connecting The Material Hose; Hose Configurations - Titan CAPSPRAY HVLP Manual Del Propietário

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

IMPORTaNT: Make sure the siphon tube is firmly inserted
into the inlet fitting, past the O-ring as shown below. If the
tube is not fully inserted, a seal will not be achieved and the
pump will not prime. DO NOT insert the notched end of the
suction tube into the inlet fitting.
NOTE: The siphon tube should go into the inlet
approximately 3/4" in order to be fully inserted.
O-ring
Inlet fitting
Siphon
tube
~3/4" (19 mm)
6. If desired, attach the siphon filter at the notched end of the
siphon tube (the larger tube). The filter will prevent any
debris in the spray material from getting into the pump.
Siphon tube
Notch
Siphon filter
7. Make sure the electrical service is 120V, 15 amp
minimum.
8. Plug the turbine power cord into a properly grounded
outlet at least 25' from the spray area.

connecting the Material hose

1. Thread the end of the fluid hose onto the Transfer Pump
fluid outlet and tighten with a wrench.
2. Thread the other end of the material hose onto the spray
gun inlet and tighten with a wrench.
© Titan Tool. All rights reserved.
Incorrect
Correct
Outlet valve
Fluid hose
Spray gun
Inlet
Fluid hose

Hose Configurations

Spraying without whip hoses
Follow the configuration below if you want to spray without the
fluid and air whip accessories.
Fluid
hose
Straps
NOTE: When strapping the hoses together, start at the
spray gun and work your way back.
NOTE: 30 ft fluid hose - included with Transfer Pump
30 ft air hose - included with turbine (25 ft air
hose included with cS75)
hose straps - included with Transfer Pump
Spraying with whip hoses
Follow the configuration below if:
1. You already have the air whip hose and you purchased a
fluid whip hose kit.
2. You have purchased both the fluid whip hose kit and the
air hose whip kit.
Fluid hose
Air whip
hose
Fluid whip
hose
NOTE: When strapping the hoses together, start at the
spray gun and work your way back.
NOTE: 30 ft fluid hose - included with Transfer Pump
30 ft air hose - included with turbine
5 ft air whip hose - included with the cS105 and
cS115
5 ft fluid whip hose - sold separately.
5
Air hose
Air hose
Straps
English
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

0524038

Tabla de contenido