Idiomas disponibles
Idiomas disponibles
Manual Instruction for:
Cable Reel - Series 605 / 625
I. Description
The cable winder features an automatic winding function. It is powered by an encapsulated,
permanently lubricated spring. Working with a desired cable length is made possible by
several catch locations per rotation.
To avoid personal injury or material damage read the instructions carefully before starting to
use the winder.
The cable winder has been inspected for quality and function before delivery.
II. Important indications
1. The voltage value (230 V) given on the drum may not be exceeded.
2. Connected devices have to be in perfect condition and be designed for the intended
operational pressure.
3. Arbitrarily retrofitting and modifications to the cable winder will cancel the warrantee.
4. Keep cable winder away from sharp and hot objects!
5. During the winding of the cable always hold the loose end tight to prevent uncontrolled
winding/clamping.
6. Regular inspection of the cable and the cable winder makes it possible to identify
damages early. Defective parts and cables must be replaced promptly.
7. Make sure that the cable winder is properly and sufficiently attached to the wall/ceiling.
8. When pulling out the cable from the winder please pull on the cable and not on the
connected device.
9. If there is damage to the winder or to the connected device, then the winder needs to be
disconnected from the power supply immediately.
10. Never use the winder in a wet environment. Keep the cable and its surroundings clean.
III. Guarantee conditions
The manufacturer provides 24 months guarantee on material and function according
to the guarantee conditions. Excepted are cables, plastic rollers and the cable stopper.
The manufacturer is not liable for damages caused by improper operation and installation by
the user. Arbitrary opening and possible removal and replacement of the cable also cancels
the guarantee.
IV. Installation
1. Installation should be done only by a trained technician. Be sure the tension and
fastening are correct.
2. The cable winder bracket (without special accessories) has bored attachment holes and
needs to be installed by only 3 screws, depending on type, to a stable wall/ceiling. For
wall mounting, the cable runout should be at the top if possible.
– 6 –
GB
