Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Fig. E
Inserting and Removing SDS Plus
Accessories (Fig. A)
WARNING: Burn hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
WARNING: Do not attempt to tighten or loosen drill
bits (or any other accessory) by gripping the front part
of the chuck and turning the tool on. Damage to the
chuck and personal injury may occur.
To insert bit, insert shank of bit about 3/4" (19 mm), no
further than 7/8" (22 mm) into chuck. Push and rotate bit
until it locks in place. The bit will be securely held.
To release bit, pull the chuck
OPERATION
WARNING: Always observe the safety instructions
and applicable regulations.
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. F)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the side
handle
, with the other hand on the main handle
3
Fig. F
3
12
back and remove the bit.
6
.
2
Depth Rod (Fig. G)
To Adjust the Depth Rod
1. Push in and hold the depth rod release button
side handle.
2. Move the depth rod
end of the rod and the end of the bit equals the desired
drilling depth.
3. Release the button to lock rod into position. When
drilling with the depth rod, stop when end of rod
reaches surface of material.
Fig. G
4
Reversing Lever (Fig. H)
The reversing lever
9
for backing out fasteners or jammed bits in drill-only mode.
WARNING: When reversing to clear jammed bits, be
ready for strong reactive torque.
To reverse the rotary hammer, turn it off and position the
reversing lever
to the right.
9
To position the lever for forward operation, turn the rotary
hammer off and push the reversing lever
Fig. H
Drilling
•
Always unplug the drill when attaching or changing bits
or accessories.
2
•
Always use sharp drill bits. For WOOD, use twist drill bits,
spade bits, power auger bits, or hole saws. For METAL,
use steel twist drill bits or hole saws. For MASONRY, such
ENglish
5
4
so the distance between the
is used to reverse the rotary hammer
9
to the left.
9
on the
5
23
Tabla de contenido
