Tabla de contenido
Idiomas disponibles
Idiomas disponibles
DWMFN-201 TOOL SPECIFICATIONS
All dimensions in inches unless otherwise specified
Description
Fastener Type
Magazine Capacity
Length
Width
Height
Weight
DWMFN-201 FASTENER SPECIFICATIONS
Tool Model
DWMFN-201 Manual
NOTE:
D
WALT tools have been engineered to provide superior customer satisfaction and are designed to achieve
e
maximum performance when used with precision D
D
WALT cannot assume responsibility for product performance if our tools are used with fasteners
e
or accessories not meeting the specific requirements established for genuine D
accessories.
TOOL SETUP
The DWMFN-201 was designed to install 1/2" to 3/4" tongue and groove hardwood flooring. The tool is factory set for
3/4" flooring. Two additional foot plates are included with this tool to accommodate 1/2" and 5/8" flooring.
Flooring products will vary and the user must ensure the tool is properly adjusted each time
flooring is being installed. Dimensions listed on the footplates are suggestions. Test fastener
placement on scrap pieces of wood before installing floor.
To change footplates:
1. Remove 4 flat head cap screws.
2. Change to desired plate.
3. Replace 4 flat head cap screws.
FASTENER PLACEMENT:
Too High
DWMFN-201
Manual Flooring Nailer
"L" Type 16 Gauge Flooring Cleats
120 cleats
13-7/16" (340 mm)
3-1/2" (89 mm)
17-1/2" (444 mm)
8.6 lbs (3.9 kg)
Fastener Type
WALT fasteners engineered to the same exacting standards.
e
Correct
Fastener SKU
Gauge
DWFLN-150
16
DWFLN-200
16
4
Length
1-1/2" (38.1 mm)
2" (50.8 mm)
WALT fasteners and
e
Flat head
cap screws
Too Low
Capítulos
Tabla de contenido
