Switching Off The Device; Troubleshooting - Medisana Relax Manual De Instrucciones

e Swedish (Swedish massage)
Press once to activate a full back massage at medium width and speed.
Swedish massage combines different types of massage; press again to
stop function. The distance between the massage heads can be adjusted
by pressing the Width z button (3 levels), the speed can be adjusted by
pressing the Speed r button (5 levels).
r Speed
For tapping, shiatsu and Swedish massage, this key can be used to adjust
the speed in 5 levels. Press the button repeatedly to select the desired
speed. The current level is shown in the display.
t Intensity
This button is used to control the intensity of the vibration massage (see
Calves p /Seatside a ). Press the button repeatedly to select the desired
intensity.
z Width (distance between the massage heads)
For tapping, shiatsu and roll massage, the distance between the massage
heads can be adjusted in 3 levels with this button. Press the botton repea-
tedly to select the desired distance. The current level is shown in the dis-
play.
u Light (switch reading lamp on/off)
i Partial (area massage)
The massage heads take the current position as the centre point in order
to perform a partial massage with a width of approx. 8 cm within the mo-
vement range of the massage heads. Press the button again to end the
function and return to the full massage.
s Spot (targeted massage)
The massage heads remain at the current position performing the currently
selected massage type. Note: Cannot be selected for roll massage.
ap Seat side/Calves (Vibration): Press the button to activate/deactivate
the vibration function of the seat side a or the footrest p . Select the inten-
sity of the vibration with the t button.
o Back and leg section adjustment: the buttons change the angle of the
back and leg section of the unit. Press the respective button to start mo-
vement, press the button again to stop movement.

3.4 Switching off the device

Press the Power button 8 on the remote control.
All functions are terminated - but the massage heads are still moving to
their parking position. Please wait a few seconds.
Then set the on/off switch (position 6 ) to position „O" and disconnect the
device from the power socket.

3.5 Troubleshooting

problem possible cause
The device does not work The device is not plugged
in properly
The device stopped wor- The device has just finis-
king hed its auto timer session
and has automatically swit-
ched to standby mode.
The device stopped wor- You may have used the
king device continuously for 30
minutes where the over-he-
at protection has been
activated.
The device stopped wor- An excessive load has
king been applied on the de-
vice.
The device is abnormally The device is likely to be
warm overused.
Noise can be heard from Noise is made by the
the device mechanical parts of the
device.
If the problem encountered is not listed, please try the following suggestions:
1. Turn off the product and unplug it.
2. Wait for 30 minutes.
3. Plug the product back to the recommended outlet and restart.
4. If the problem persists, contact the authorized service center.
The service centre address is shown on the attached leaflet.
GB
3 Operating
suggestion
Ensure the voltage on the
device corresponds to the
local mains voltage and
then plug in again. Make
sure the outlet is properly
working.
If you want another sessi-
on, press the power button
again.
Unplug the device and let
it cool down for 30 minutes
before you use it again.
Reduce the excessive load
and start again.
Unplug the device and let
it cool down before using it
again.
This is normal and does
not mean that the device is
faulty.
7