Interrupting / Aborting A Cycle - SciCan HYDRIM M2 Manual Del Operador

5. Instructions for Use
P1 Regular
FILLING
29ºC
257
P1 Regular
Cycle Complete
P1 Regular
Instruments
not processed
OK
The cycle will start by draining the unit for 20 seconds. The bar
on the screen indicates the progression of the cycle. The stage
within the cycle is shown beneath the bar (eg. Filling, Rinsing).
The cycle count and chamber temperature are displayed.
When the cycle is complete, the program name and "Cycle
Complete" is displayed, and the unit beeps three times.
Press to open the door. Use gloves to unload the
instruments. After all cycles, exercise caution as the
instruments, trolley, baskets and cassettes may be hot. Inspect
the instruments for debris prior to packaging / sterilising.

5.5 Interrupting / Aborting a Cycle

The door of the Hydrim is locked during the cycle. If the STOP
button is pressed, the cycle is aborted and cannot be re-start-
ed. The message "Draining. Please wait" will appear. The unit
will drain. Then the message "Instruments not processed" will
appear. Press OK. Open the door by pressing
if handling the instruments. Exercise caution as instruments,
trolley, baskets and cassettes may be hot. The cycle must
be repeated to ensure that instruments are properly
processed. Note that if the drying phase of the cycle is
interrupted, the critical parts of the cycle are complete
and the message displaying the program name and "Cycle
Complete. Drying interrupted" will appear.
41
. Use gloves