Proper Usage; Putting Into Operation; Technical Data - EINHELL GAS 4,8 F Manual De Instrucciones

Anleitung GAS 02.11.2001 11:09 Uhr

3. Proper usage

The Accu Shears GAS 4.8F; GAS 4.8FG; GAS 7.2F;
GAS 7.2FG have been designed for the cutting of
grass edges and small grass surface in private
gardens/hobby area.
It is absolutely necessary to observe the
manufacturer's operating instructions to ensure the
unit's proper functioning.
The operating instructions als contain advice for
service, maintenance and repair.
Caution!
For safety reasons, the unit should not be used
for cutting hedges or chopping in the sense of
composting.

4. Technical data

Cutting width
Operating time per charge
Cutting length per charge
NC battery
Power pack:
Mains voltage
Output:
Nominal voltage
Nominal current
Nominal power
Cutting width
Operating time per charge
Cutting length per charge
NC battery
Power pack:
Mains voltage
Output:
Nominal voltage
Nominal current
Nominal power
Seite 9

5. Putting into operation

Charging the NC battery
1. Open the lid of the battery box and pull the
2. Check that the mains voltage specified on the
3. Insert the battery in the charging adapter. The red
GAS 4.8 F
70 mm
max. 40 min
If you find it impossible to charge the battery, please
ca. 800 m
check
-
4.8 volts / 1300 mAh
-
230V ~ 50 Hz
If you still fail to charge the battery, please return
6 V
300 mA
to our Customer Service Centre.
1.8 VA
Timely recharging of the NC battery will help to pro-
long its useful life. This is particularly important when
you notice that the battery-powered grass cutter is
beginning to cut less efficiently.
GAS 7.2
Never allow the battery to discharge fully. You will be
70 mm
left with a defective NC battery!
max. 55 min
ca. 1100 m
Using the Shears
7.2 volts / 1300 mAh
The area to be cut should first be cleared of stones
and other solid objects. Pull the knife guard toward
the back until it latches firmly in place. The starting
230V ~ 50 Hz
inhibitor prevents your Einhell grass cutter from
being switched on unintentionally. To start up the
battery-powered grass cutter, slide the starting inhibi-
7.2 V tor towards the back to unlock it. Then press the ON
button. When you are finished with your work, relea-
275 mA
se the catch and push the knife guard back to the
1.98 VA
front again in order to rule out injury.
battery out of the handle.
rating plate is the same as your local mains
voltage. Connect the charging cable to the
charging adapter and plug the charger in a
socket-outlet. The green LED on the charging
adapter indicates that charging voltage is
available.
LED indicates that the battery is being charged.
The charger does not switch off automatically
when the battery is fully charged. An empty
battery requires a maximum of 12 hours to be
charged. Charging takes less time according to
the level of the residual charge. While the battery
is being charged it may become warm. This is
normal.
whether there is voltage at the socket-outlet,
whether the charging contacts on the battery
charger make proper contact.
the power pack
the charging adapter
and the battery
GB
9