General Specification - Facom 712A Manual Del Usuario

página de 113

/ 113
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

• Remaining endangerment: When an input terminal is connected to dangerous live

potential, this potential can occur at all other terminals!

• cAt iii - Measurement Category III is for measurements performed in the building

installation. Examples are measurements on distribution boards, circuit breakers,

wiring, including cables, bus-bars, junction boxes, switches, socket-outlets in the fixed

installation, and equipment for industrial use and some other equipment, for example,

stationary motors with permanent connection to the fixed installation. Do not use the

meter for measurements within Measurement Categories IV.

caution

To avoid possible damage to the meter or to the equipment under test, follow these

guidelines:

• Disconnect circuit power and discharge all capacitors before testing resistance,

diode, capacitor and continuity.

• Use the proper function for your measurements.

• Before rotating the rotary switch to change functions, remove test leads from the

circuit under test and remove the jaws from the clamped conductor.

electrical symbols

Alternating Current

Direct Current

Both direct and alternating current

Caution, risk of danger, refer to the operating manual before use.

Caution, risk of electric shock.

Earth (ground) Terminal

Conforms to European Union directives

The equipment is protected throughout by double insulation or reinforced

insulation.

iNtroDUctioN

This meter is a 3 3/4-digit autorange digital clamp meter for measuring DC and AC

voltage, DC and AC current, resistance, temperature, diode and continuity. It is easy to

operate and is an ideal measurement tool.