Idiomas disponibles
Idiomas disponibles
GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1
MRA screen
3
Round head screws, M5 x 25 mm
3
Plastic washers, 12 x 5 mm
1
Spacer, 6 mm
3
O-rings, 4.5 x 1.5 mm
2
Spacers, 10 mm
1
Edge protector strip with end sleeves
How to mount the screen on your motorbike:
1. Stand your motorbike up on a level surface.
2. Remove the original screen; make sure that you do not drop the black dash fairing
underneath it.
3. Insert the M5 x 25 mm round head screws with the plastic washers into the two upper
holes on the MRA screen.
4. Insert the 10 mm spacers with one O-ring each onto the screws from inside (P1).
5. Insert the M5 x 25 mm round head screw with the plastic washer into the lower hole
in the MRA screen, and place the 6 mm spacer with the O-ring onto the screw from
behind (P1).
6. Position the fairing screen and tighten the screws.
7. Install the edge protector strip onto the screen as shown in P2. Place the end sleeves
over the end of the edge protector strip and gently squeeze the sleeves with a pair of
pliers to secure the edge protector strip.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: [email protected]
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
BMW F800R 2015-
Article No..
---
Torx TX 25 socket spanner
10641
Allen key, 3 mm
10635
11038
10992
10633
---
3
Required tools
