Beurer BARBERS CORNER HR 5000 Instrucciones De Uso página 23

• In order to adjust the cutting length on the comb
attachment, slide the sliding switch on the rear of
the comb attachment to the desired cutting length
as shown.
• Press the ON/OFF
display begins to light up.
• Guide the device slowly through the hair. Ensure that the comb at-
tachment sits as flat on the head as possible.
• Always only trim small areas.
• Cut the hair against the direction of growth. If the hair grows in dif-
ferent directions, use the device in multiple directions.
• Press the ON/OFF switch
use. The operating display turns off.
Cutting hair without the comb attachment
If you want to cut your hair very short (0.5 mm to
2.5 mm), you can use the device without a comb
attachment.
• If a comb attachment is attached to the device,
pull the comb attachment upwards off the device.
• To set the precision adjustment level, use the dial
for precision adjustment on the rear of the device.
You can now set the desired cutting length to be-
tween 0.5 and 2.5 mm.
• Start the application.
Thinning hair
The device has a thinning function. The thinning function can be
used to reduce the volume of hair as only some of the hair is gath-
ered and cut.
• In order to use the thinning function, slide the
sliding switch for the thinning function on the
front of the device to the left.
Cutting precise contours (e.g. sideburns or neck hair)
You can also use the device to cut particularly precise contours, such
as sideburns or neck hair.
• If a comb attachment is attached to the device, pull the comb at-
tachment upwards off the device.
• Turn the device so that the front side of the device is facing your
head.
• Move the device slowly from the top downwards.
switch to switch on the device. The operation
again to switch off the device after
23