Tabla de contenido
Idiomas disponibles
Idiomas disponibles
result in unevenly sanded surfaces and/or dam-
age to the sandpaper itself.
NOTE: Holes in sandpaper must be lined up
with the holes in the backing pad in order for
the dust collection feature of the sander to
function properly.
INSTALLATION AND LUBRICATION
Size air supply line to ensure tool's maximum
operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of pip-
ing, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of
hose and use an anti-whip device across any
hose coupling without internal shut-off, to
prevent hose whipping if a hose fails or cou-
pling disconnects.
MAINTENANCE
Maintenance frequency is shown in the illus-
tration below.
PARTS & MAINTENANCE
Tool repair and maintenance should only be
carried out by an authorized Service Center.
When the life of the tool has expired, it is
recommended that the tool be disassembled,
Diagráma de conexión de Aire /
Air line assembly
48h
90 psi
E N G L I S H •
degreased and parts be separated by material
so that they can be recycled.
LUBRICACIÓN
The parts shown in the assembly for proper
operation of your air tools are identified as
follows:
1. Air filter.
2. Regulator.
3. Lubricator.
4. Emergency shut-off valve.
5. Hose diameter.
6. Thread size.
7. Coupling.
8. Safety Air Fuse.
9. Oil.
10. Grease (During assembly).
TECHNICAL DATA
SANDER CAPACITY
NO LOAD SPEED
WEIGHT
AIR CONSUMPTION
AIR INLET
HOSE DIAMETER
REC. AIR PRESSURE
U ser' s manual
9,3 cm x 16,5 cm
8 000 r/min
1,8 kg (4 lb)
4 cfm
1/4 NPT
3/8" (10 mm)
90 PSI
24h
7
Tabla de contenido
