Toro QUIETECH Super Blower Vac Manual Del Operador página 3

Read operator's
manual
Consult technical
manual for proper
service procedures
Do not open or
remove safety shields
while engine is
running
Wear eye protection
Assembly
Note: Refer to Figures section at the back of the manual.
Note: Always turn off unit and unplug from electrical outlet
before adding or switching attachments.
Blower
1. Slide tube onto blower outlet until tabs on tube snap into latch
(Fig. 2).
2. Install inlet cover. Inlet cover must be securely locked into
position, activating interlock switch, before blower will operate
(Fig. 1).
Note: Blower tube must be attached to housing when operating in
the blower mode.
Note: Noise reduction is achieved in blower mode only.
Electrical
shock/electrocution
Disconnect power
Severing of fingers or
hand—impeller blade
Vacuum
1. Grasp inlet cover and rotate it counterclockwise to remove
(Fig. 1).
POTENTIAL HAZARD
Motor impeller rotates for a few seconds after blower
is turned off.
WHAT CAN HAPPEN
Rotating impeller can cut or injure fingers.
HOW TO AVOID THE HAZARD
Never remove inlet cover when motor is operating or
when unit is plugged in.
2. Hold vacuum tubes vertically and place blower inlet over top
of tube (Fig. 3). Tubes will only fit one way in blower inlet.
3. Rotate unit clockwise until pointer on vacuum tube aligns with
pointer on housing (Fig. 4, 5 & 6).
Note: Vacuum tube and housing pointers must be aligned at locked
position before blower will operate.
4. Slide bag collar into bag opening until bag collar flange is past
the Velcro strap (Fig. 7). Line up bag seam with tab on collar.
Tighten Velcro strap to secure bag to collar (Fig. 7). Close bag
zipper. Bag should appear as shown in Figure 8 when correctly
assembled.
Note: Attaching the bag to the collar is a onetime assembly.
5. Slide bag collar onto blower housing outlet until tabs on bag
collar snap into latch (Fig. 9).
2