Connecting A Gate Motor; User Guide; Videophone Settings; Settings On The Camera - Extel MEMO 2 Instrucciones De Uso

Important: The strike plate or electric lock that you are about to install must have a mechanical memory, like all
EXTEL products. For wiring, see the label on the back of the camera.
c. Connecting a gate motor
Directly connect to contacts 3 and 4 on the back of the camera. The camera delivers a "dry" contact with no
current, to be connected to the "push button" control of your automatic opener.
Note that this function is only available when the screen is displaying the video from outside. A
light appears as confirmation.

6. USER GUIDE

a. Videophone settings (fig.2)
4 settings are accessible at the top of the monitor:
• Melody selection (9 bell sounds available) (3). To confirm your choice press the key
• Light settings (4)
• Volume settings for the melody (5).
• Volume settings for sounds coming from outside, music and videos (6).
b. Settings on the camera (fig.3)
If you notice that the camera lens is not correctly aligned when installing the monitor and the intercom panel in
their final positions, you can compensate for this misalignment using the adjustment holes located on the back of
the intercom panel. Caution, you can only compensate by a few centimetres in height.
GENERAL:
• To access the videophone menus press the key
• To confirm your choice press the key
• To go back to the previous menu or delete a file, press the key
• To navigate use the
• The symbol flashes at the bottom of the screen to indicate that a visitor has called and that a photo or video
was taken; you will find these recordings in the photo or video folder, depending on your configuration *.
• If no buttons are pressed for 3 minutes, the monitor switches to sleep mode for one hour, after which the screen
turns off completely (it will turn on again if there is another call).
• If the power is cut off for more than 7 mins, the dates and times must be reconfigured.
• When the SD card memory is full, the
recording (minimum 100MB - maximum 32GB)
• When the internal memory is full, the
* The visitor memory function is activated originally in photo mode. To activate the video mode, insert an SD card and follow
the instructions chap 6d.
c. Using the basic functions of the videophone
• Pressing the button on the intercom panel activates a tone and the monitor turns on for about 30 seconds. Once
the visitor has been identified, press the
Note: - Pressing the
• When you have finished talking, wait until the time delay of about 60 seconds has expired, or press the
keys to turn the monitor off.
• Refreshing the picture:
To refresh the picture for an additional 60 seconds, press the
• Strike plate control:
The strike plate or the lock are triggered when the
• Automatic opener control:
(fig. 6)
and keys.
symbol appears and you need to add more memory in order to activate
symbol appears
key to begin talking.
key only once is sufficient to establish communication with the intercom panel.
CFI EXTEL MEMO 2 - 03/2013
key.
button is pressed.
or
GB4