Making Connections; Input Channels; Master Section - Phonic POWERPOD 630RW Manual Del Usuario

MAKING CONNECTIONS

Input Channels

The Powerpod 630RW features a total of 6 channels, 2 of which
accept stereo signals. Each channel features a microphone XLR
jack and at least one 1/4" Phone Jack for balanced and unbalanced
connections. Each stereo channel features different inputs jacks,
accepting either microphone inputs or stereo line inputs.
1. XLR Lo-Z Inputs
These XLR microphone inputs can be used in conjunction with
a wide range of microphones, such as professional condenser,
dynamic or ribbon microphones, with standard XLR male
connectors. With low noise preamplifiers, these inputs serve for
crystal clear sound replication.
NB. When using an unbalanced microphone, please ensure phantom power
is switched off. However, when using condenser microphones the phantom
power should be activated.
2. 1/4" Hi-Z and Super Hi-Z Input Jacks
These inputs accept typical 1/4" TRS or TS unbalanced inputs. The
Hi-Z inputs accept balanced TRS inputs, and are for Microphone
to line-level device (such as synthesizers and drum machines),
where the Super Hi-Z inputs accept TS unbalanced sources, and
can be used in conjunction with devices with higher impedance
levels (including electric guitars and basses).
NB.When using a line-level device on your mixer, the PAD -25 button should
be initiated.
3. Stereo Channel Inputs
Each of the Powerpod 630RW powered mixers provides 2 stereo
input channels, the inputs of which differ slightly to the mono
channels. The 3-pin XLR inputs featured are for the addition
of microphones with typical XLR male inputs, where the 2 Line
1/4" TS jacks are for the addition of various stereo line level input
devices, such as keyboards. If you wish to use a monaural device
on a stereo return input, simply plug the device's 1/4" phone jack
into the left (mono) stereo input and leave the right input bare.
The signal will be duplicated to the right due to the miracle of jack
normalizing.
2
1
2

Master Section

4. Tape In (L and R)
The first of these inputs accommodates RCA cables from such
devices as tape and CD players. The line from this feed is directed
to the Tape In mix, before being fed through to the Main 1/2 mix.
5. Record Outputs (L and R)
As with the Tape In ports, these outputs will accommodate RCA
cables, able to be fed to a variety of recording devices. Also,
similar to the Tape In ports,
6. AUX Inputs
This TS input connects the mixer with parallel external devices,
such as sub mixers or external effect processors, receiving the
processed signal from another source and feeding it to the AUX
mix.
4
7. Foot Switch Jack
This port is for the inclusion of a non-latching foot switch, used to
remotely adjust properties of the built-in Digital Effect processor.
The Powerpod 630RW features a single foot switch jack, which
allows the user to remotely turn on and off the digital effects.
8. EFX (Effect) Outputs
These 1/4" TS outputs are the final output from the EFX send
mix. This feed may be used to connect to an external digital effect
processor, or even to an amplifier and speakers, depending on
your desired settings.
3
6
MIN MAX
5
8
7
POWERPOD 630RW