Descaling; Care Of Stainless Steel Parts; Storage; Faults And Troubleshooting - Beem Tea Joy Royal Plus Manual De Instrucciones

7.1

Descaling

Use descalers with citric acid or vinegar essence (approx. 5 % acid).
For descaling use only an environmentally-friendly descaling agent and proceed only
according to the information of the manufacturer.
Do not use formic acid-based descalers.
Water boiler
The water boiler (1) should be descaled after 20 - 40 uses, or possibly before if
necessary. If lime scale covers the bottom of the water boiler (1) the appliance can be
damaged (accumulation of heat). You can see that lime scale has formed when there is
white discoloration on the inside of the water boiler (1).
1. Use the descaling agent according to the information of the manufacturer for the
water boiler (1).
2. Empty the water boiler (1) and remove the remnants with a wet cloth.
3. After descaling fill the water boiler (1) twice with fresh water and let it boil and pour
it away.
7.2

Care of stainless steel parts

For regular care and also for removing stubborn stains on stainless steel parts we
recommend the INOX METAL POLISH from Beem. This polish restores the original sheen
to appliances. INOX METAL POLISH is available in tubes and is suitable for all objects
made of stainless steel, chrome, brass, copper, aluminium, silver and also hard plastics.
INOX METAL POLISH is also used in factories for polishing stainless steel. You can order
INOX METAL POLISH from your specialist dealer, by telephone from us or on our website
www.beem.de.
Please note that the label and imprint on the stainless steel surfaces may come off if
cleaned with metal polish or other chemicals.
7.3

Storage

Let the appliance cool down fully.
Empty the water boiler (1).
8

Faults and troubleshooting

ATTENTION! In the event of a fault during use, unplug the appliance.
If the water and tea boiling station fails to operate, please check whether
the appliance is plugged in.
the water boiler (1) is switched on. (Signal lamp (5) should illuminate!)
the water boiler (1) is empty or filled below the MIN mark.
the on/off button (8) of the keep warm plate is switched on.
other appliances with high wattage are in operation simultaneously, causing the main
fuse to blow. First disconnect the appliance from the mains. Then reconnect the fuse.
If the main fuse blows, this is normally an indication of a fault. In this case, qualified
service personnel should check the appliance.
BEEM – Elements of Lifestyle
Seite/Page/Page/Página
22 / 60