Oster GCSTCC3000 Manual De Instrucciones página 19

Caring For Your Iron After Use
1. To turn off the iron, move the Steam Lever to Dry
WARNING: NEVER yank power cord when unplugging iron. This can damage the cord.
2. If you do not use your iron on a daily basis, empty the water reservoir after each use
for a longer iron life. To do so, unplug the iron, turn the iron upside down, open the
Water Fill Hole Cover, and allow water to flow from the Fill Hole. Shake the iron gently
to remove trapped water drops.
1. Unplug iron and allow to cool.
2. Empty water reservoir after each use and move Stem Lever to the Dry
3. Loosely loop the power cord around the iron and store iron in vertical position on the
Heating Base.
CAUTION: Wrapping the cord around the Heating Base too tightly can damage the cord.
Maintaining And Cleaning Your Iron
USING SELF-CLEAN FEATURE
Use the Self-Clean feature once a month to maintain optimal iron performance.
1. Unplug iron and remove from Heating Base.
2. Move Steam Lever back and forth to remove debris and minerals from Steam Valve.
This keeps water flowing into the steam chamber.
3. Fill water reservoir with tap water to MAX line.
4. Set iron and lock onto Heating Base the plug in iron and heat up for a few seconds.
5. Unplug iron and remove from Heating Base. Holding iron over a sink in a horizontal
position, press Self-Clean Button
steam vents on the soleplate. Slowly rock iron side to side and front to back for 30
seconds. Dip nose of the iron slightly below the rear to circulate water. Release Self-
Clean Button after one minute.
6. Open Water Fill Hole Cover and empty remaining water. Carefully dry soleplate with
a towel after iron has cooled.
7. Plug in iron and heat for 1 minute to dry out completely. Unplug the iron and allow to
cool.
Clean soleplate after every 30 uses, or more frequently if starch is used or build-up starts
to accumulate. Before cleaning, ensure iron is unplugged and cool.
WARNING: To avoid the risk of electric shock, do not immerse the iron in water or other
liquids.
Note: Do not use abrasive cleansers, scouring pads or vinegar to clean the soleplate.
This will damage the finish.
Storing Your Iron
and hold. Water will begin dripping from the
Cleaning Soleplate
English - 7
setting and unplug the iron.
setting.