Yakima HangOut 3 Manual De Instrucciones página 5

If nOt attachIng upper hOOks tO glass Or plastIc, cOntInue here.
aDJust uppeR
stRaps.
position the frame as determined in
step 6. the upper straps should hold
the carrier in place.
place lOweR stRap HOOKs.
warnIng: Do not attach thE lowEr
hooks to glass or plastIc!
if lower hooks must attach to glass or plastic, follow
anchor installation instructions on the next page.
center the carrIer On the car,
position the side strap hooks.
position hooks
at side mounting
points directed
by the Fit sheet
notes.
tigHten siDe stRaps.
Pull the straps
tighter with two
hands.
1035818C - 5/27
Place where directed by fitlookup.
yakima.com, or Fit notes.
tigHten
uppeR
stRaps.
Pull the straps
tighter with
two hands.
Adjust upper straps by pulling on the ends. (Loosen by
unlIstED vEhIclEs:
lOweR HOOKs
• The first choice is the bottom of the
trunk/hatch.
• The second choice is under the
bumper if there is a rigid, metal
attachment point.
• The third choice is tie-down hooks
underneath the vehicle or holes in
the vehicle's frame.
cautIons:
• Keep straps away from hot vehicle exhaust!
• Keep straps from rubbing on sharp metal edges!
• Do not attach lower hooks to plastic bumpers.
note: if it is difficult to get the hook in, insert it at a
wider section and then slide it into place.
cOntinue tO step 19
pressing the metal buckles.)
unlIstED vEhIclEs:
siDe HOOKs
• Mount to the side of the trunk/hatch.
• Position the hooks so they will not
slide up or down when tightened.
bundle the extra
strap ends into the
band.