Yakima Hi-Lift Jack Bracket Manual De Instrucciones página 3

Measure the length
of your jack's handle.
SECOND BRACKET, SECOND HOLE...
• Insert bolt, with lock
washer, and washer.
• Add washer.
• Attach coupling nut
(with attached plate).
load the Jack.
Use care when lifting
a heavy jack!
foot PLAtE
warning
ALWAYS INSTALL THE JACK ON THE
VEHICLE'S PASSENGER SIDE.
The jack's foot plate must be at the back
of the vehicle, with the handle below.
1033017D-3/12
Position the second bracket at about
2" (5cm) shorter than measured distance.
Second bracket must always contact
the jack near the end of its handle.
Secure jack handle to
jack with strap.
SECOND BRACKET, FORWARD HOLE...
• Finish with flat washer
and nut.
• TIGHTEN.
(Lock HoLE)
SECURE THE JACK TO THE BRACKETS.
• Insert short bolt,
with lock washer,
and flat washer.
• Secure at both
brackets.
• TIGHTEN.
coupling nut, loosen the bracket and
Insert bolt, with washer,
through backing plate.
(BAckING PLAtE)
tighten all
nuts & bolts
before loading
the jack.
If jack's holes will not align to
adjust until bolt installs easily.