Setup Wizard; Mode Selection; Audio Playback - Lenco DIR-140 Manual Del Usuario

13. Up Cursor button
14. Left cursor button
15. Right cursor button
16. Down cursor button
16. Enter button
17. OK button
18. Vol- button
19. Vol+ button
20. Input letters and numbers
21. Fav button
22. Back button
4. INITIAL USE
Before operation, please make sure that the VOLTAGE mentioned on the power supply is same as
the voltage of your local area.
Use the supplied mains adaptor to connect the device to a household mains socket.
4.1

Setup wizard

When radio is started for the first time, it runs through a setup wizard to configure settings for
date/time and network. Once this has finished, the system is ready to use in most modes.
Note: To change these settings later, select Menu>System settings>and select the required settings
options. To run the setup wizard again, select Menu>System settings>Setup wizard
The Setup wizard guides you through the basic setup parameters for Time/Date and Network
connection. To change any settings later all setting functions are accessible from the Settings Menu.
5. Operation
After the initial setup, radio is ready for operating in most Modes.
5.1

Mode selection

From the Main Menu select a mode and press OK. Alternatively press Mode button repeatedly to
switch to different mode. After a brief moment radio switches to that mode. The last station or track
previously used in that mode is selected. If this is not possible, radio scans for relevant stations,
networks, or prompts the user for appropriate input.
5.2

Audio playback

The common local controls for audio playback are available in all listening modes:
9