Advance Planning; Ceiling Support Structures - ELICA Arietta DKI001MX 36 Guía De Instalación Y Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Advance planning

Determine the exact location of the vent hood.
Locate the template packed with the literature.
Plan the route for venting exhaust to the outdoors.
Use the shortest and straightest duct route possible. For satisfactory performance duct run should not exceed
100' equivalent length for any duct configurations.
Refer to "Duct Fittings" chart to compute the maximum permissible length for duct runs to the outdoors.
Use 8" round metal ductwork only.
Installation will be easier if the vent hood is installed before the cook-top and countertop are installed.
EXAMPLE A
7-1/16 ?
16? joist
spacing
Top view – ceiling joists parallel to front of hood
EXAMPLE B
16? joist
spacing
7-1/16 ?
Top view – ceiling joists run perpendicular to front of hood
10-1/16 ?
Install cross-framing
symmetrically over
duct/cooktop
centerline
8" duct
2x4 cross
framing
Align duct
Front
of
to center of
hood
cooktop
10-1/16 ? install
cross-framing
symmetrically over
duct/cooktop
centerline
2x4 cross
framing
8? duct
Front
Align duct
Cooktop
of
hood
outline
to center of
cooktop

Ceiling Support Structures

• At the hood location, install 2"x 4" cross framing
between ceiling joists as shown. (2"x 4" are
required to support the weight of the hood.)
• Arrange cross framing in the ceiling to suit the
existing structure.
• Your ceiling joists will be like one of the following
examples.
Cooktop
outline
NOTE: Do not cut the duct
opening shown on the template
for the recirculating installation.
EXAMPLE C
10-1/16 ? install cross-framing
symmetrically over duct/cooktop
centerline
7-1/16 ?
16? joist
spacing
Top view – ceiling joists at angle to front of hood
12
Drill 3/16"
Pilot Holes
Cut a 1 ? Dia.
Approx. 1 1/2"
Wire Access
Hole
Deep
10 1/4"
to
Centerline
of Holes
8 1/4"
to
Centerline
of Holes
36" Hood
Template
Cut a 1 ? Dia.
Wire Access
Hole
8 1/4"
to
Centerline
of Holes
FRONT OF HOOD
2x4 cross
framing
8? duct
Align duct
Front
of
to center of
hood
cooktop
Drill 3/16"
Pilot Holes
Approx. 1 1/2"
Deep
Cooktop
outline

Capítulos

Tabla de contenido
loading

Tabla de contenido