Bostitch DSA-3519-U Instrucciones De Funcionamiento página 13

A. Remove the magazine from the tool
B. Using a pair of pliers, remove the jammed staple
C. Refit the magazine
SERVICE PARTS LIST
m CAUTION: Repair, modification and inspection
of BOSTITCH Power Tools must be carried out by a
BOSTITCH Authorised Service Center.
The Parts List supplied with this tool will be helpful if
presented with the tool to the BOSTITCH Authorised
Service Center when requesting repair or other
maintenance.
TROUBLE SHOOTING
PROBLEM
Skipping fasteners/
intermittent feed
Fasteners jam in the tool
Slow drive speed or
stalling
Poor clinch
Multiple fasteners driven
at once
Staple is only clinching
the top layer of corrugate
Loose clinch
CAUSE
Loose magazine
Fasteners out of spec.
Dirt/debris in the magazine
Dirt/debris in the drive channel
Wrong size fasteners
Bent fasteners
Broken/chipped driver
Worn pusher
Loose magazine
Fasteners out of spec.
Dirt/debris in the magazine
Dirt /debris in the drive channel
Worn/damaged pusher spring
Discharged Battery
Depleted Battery
Cardboard too thick
Wrong leg length setting
Worn driver guide
Broken/bent clinchers
Loose magazine
Depth setting too shallow
Fasteners are too short
Cardboard too thick
Clinch setting too loose
Fasteners are too long
In the operation and maintenance of power tools, the
safety regulations and standards prescribed in each
country must be observed.
MODIFICATIONS
BOSTITCH tools are constantly being improved and
modified to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without prior
notice.
CORRECTION
Re-engage the magazine release lever
Replace with recommended fasteners
Clean and dry the magazine
Clean the drive channel
Replace with recommended fasteners
Discontinue using these fasteners
Replace driver
Replace pusher
Re-engage the magazine release lever
Replace with recommended fasteners
Clean and dry the magazine
Clean the drive channel
Replace pusher spring
Recharge battery
Replace battery
Reduce cardboard thickness
Set leg length according to clinchers and fasteners
Replace the driver guide
Replace clinchers
Re-engage the magazine release lever
Set the tool to a deeper drive setting
Replace with longer fasteners
Reduce cardboard thickness
Adjust the clinch setting tighter
Replace with shorter fasteners
GB