Elettro CF 3465 Manual De Uso página 22

EN
Translated copy of the original Italian text
• Keeping the gun in a vertical position (90°),
press the trigger (2) to start the welding (if the
AUTOSTART function is enabled, the welding will
start automatically).
• When the work is completed, remove the accessory
by tilting it to one side.
5.4.4 Using the slide hammer
5.4.4.1 Tri-hook (star) washer
(See attached image A4)
• Install the slide hammer (1) on the gun (2) as
described in the "Fitting electrodes" section.
• Weld the tri-hook washer (3) to the surface to be
straightened as described in the "Using electrodes
and welding accessories" paragraph.
• Pull the slide hammer weight back against the stop
(1) until the surface reaches the desired shape.
• When the work is completed, remove the accessory
by tilting it to one side.
5.4.4.2 Ø16 washer
(See the attached image A5)
• Weld the Ø16 washer (1) to the surface to be
straightened as described in the "Using electrodes
and welding accessories" paragraph.
(See the attached image A6)
• Fit the hook (2) to the slide hammer (3) as described
in the "Fitting electrodes" section.
• Insert the hook into the previously welded washer
and pull the slide hammer weight back against the
stop (3) until the surface reaches the desired shape.
• At the end of the work, remove the accessory by
tilting it to one side.
5.4.4.3 Straight pull ring or twisted pull ring
(See the attached image A7)
• Weld the pull ring (or twisted pull ring) (1) onto the
surface to be straightened as described in the "Using
electrodes and welding accessories" paragraph.
(See the attached image A8)
• Fit the hook (2) to the slide hammer (3) as described
in the "Fitting electrodes" section.
• Insert the hook into the previously welded pull ring
and pull the slide hammer weight back against the
stop (3) until the surface reaches the desired shape.
• When the work is completed, remove the accessory
by tilting it to one side.
5.4.5 Using the flattening electrode
(See the attached image A9)
• Attach the flattening electrode (1) to the gun (2) as
described in the "Fitting electrodes" section.
• Switch on the machine as described in the "Switching
on the machine" section.
• Set the program or adjust the welding parameters
as described in the "Selecting programs and setting
welding parameters" section.
• Hold the gun (2) properly by the handle.
• Push the gun hard against the residues to be
flattened and press the trigger (3) to start the
welding (if the AUTOSTART function is enabled, the
welding will start automatically).
5.4.6 Using a carbon electrode for localised
heating
(See the attached image A10)
• Attach the carbon electrode (1) to the gun (2) as
described in the "Fitting electrodes" section.
• Switch on the machine as described in the "Switching
on the machine" section.
• Set the program or adjust the welding parameters
as described in the "Selecting programs and setting
welding parameters" section.
• Hold the gun (2) properly by the handle.
• Keeping the gun in a vertical position (90°), press
the trigger (3) to start the welding.
• The heating is done by moving the electrode around
on the metal sheet while exerting slight pressure.
(Make a circular motion at a constant speed, without
stopping).
• When the welding is started (by the trigger or
automatically with the AUTOSTART function), the
set current is supplied for a maximum of 4 seconds;
if this time is insufficient to produce the desired
heating, release the trigger and press it again.
EN-6