Elettro CF 3465 Manual De Uso página 21

• Press the knob to enter edit mode.
• Turn the knob to adjust the electrical current to the
desired value.
• Press the knob once more to confirm the selection.
• Turn the knob until the preset program that you
intend to edit is activated (LED on).
• Press and hold the knob for 5 seconds.
• The display shows the time and power settings
updated in the program.
• Press and hold the knob for a further 5 seconds to
save the selection.
5.4 Using the welder
DANGER
THE machine must not be used by
persons with biomedical implants (e.g.
pacemakers,
without first consulting their doctor.
DANGER
Remove the electrodes using a pair of
pliers, taking the greatest care to avoid
any contact with hot parts.
WARNING
Store the electrodes in a suitable place
where they can cool down in total safety
(for example, on the ground).
Keep the surrounding area free from
flammable materials.
WARNING
Operators must wear suitable personal
protective equipment (goggles, gloves,
aprons or other clothing) to protect
themselves from spatter of incandescent
material.
NOTE
Welding residues can be removed using
the flattening electrode as described
in the "Using the flattening electrode"
section.
5.4.1 Preparing the welding surface
It is essential that any layers of paint covering the
surface are completely removed in order to obtain a
good weld.
The welding surface must also be perfectly dry and
free from dust, oil and grease.
Translated copy of the original Italian text
metal prostheses etc.)
5.4.2 Welding the spot earth
NOTE
The spot earth should be welded as close
as possible to the area on which the
subsequent work is to be carried out.
CAUTION
Adjustment of the welding parameters
is left to the operator's own discretion,
as this can vary noticeably in relation to
numerous factors, such as:
• The distance of the welding from the
position of the spot earth.
• The type of welded element (tri-hook
washers, round washers, wiggle wire
etc.), the type of welding (heating with
a carbon electrode) or the contact
surface and shape.
• The material on which the welding is
performed.
(See attached image A2)
• Hold the gun (2) properly by the handle.
• Place the spot earth (3) on the surface where it is to
be welded.
• Keeping the gun in a vertical position (90°) close
to the spot earth, press the trigger (4) to start the
welding (if the AUTOSTART function is enabled, the
welding will start automatically).
• Screw the protective ring (5) until it is rests against
the surface.
• Proceed with the subsequent work.
• When the work is completed, remove the spot earth
by tilting it to one side.
5.4.3 Using electrodes and welding accessories
CAUTION
Adjustment of the welding parameters
is left to the operator's own discretion,
as this can vary noticeably in relation to
numerous factors, such as:
• The distance of the welding from the
position of the spot earth.
• The type of welded element (tri-hook
washers, round washers, wiggle wire
etc.), the type of welding (heating with
a carbon electrode) or the contact
surface and shape.
• The material on which the welding is
performed.
(See attached image A3)
• Hold the gun (1) properly by the handle.
• Place the accessory on the surface where it is to be
welded.
EN-5
EN