Parts Description; Control Pad - Orbegozo DH 1039 Manual De Instrucciones

DH 1039

PARTS DESCRIPTION

CONTROL PAD

1. Control panel
2. Air intake grille
3. Water bucket
4. Air filter (behind the air intake grille)
5. Handle
6. Air Outlet grille
7. Power cord band (Used only when storing the unit.)
8. Drain hose outlet
9. Power Cord
10. Power Plug
1. Power on indicator light(green)
2. Bucket full indicator light(red)
3. Continuous operation on indicator light(green)
4. Display
• Shows the set % humidity level while setting, then shows the
actual(+5% accuracy) room % humidity level.
• Error Codes:
− E1- Humidity sensor error--Unplug the unit and plug it back in. If error
repeats, call for service.
− E2- Temperature sensor error-- Unplug the unit and plug it back in. If
error repeats, call for service.
− EC- Refrigerant leakage detection-- With this new technology, the
display area will appear EC when the unit detects refrigerant leakage ,call
for service.
• Protect Codes:
− P1- Unit is defrosting-- Allow the unit to automatically defrost. The
protection will clear after the unit self-defrosts.
− P2- Bucket is full or bucket is not in the right position
5. POWER Pad: Press to turn the dehumidifier on and off.
6. Humidity Set Control Pads: The humidity level can be set within a
range of 35%RH(Relative Humidity) to 80% RH(Relative Humidity) in 5%
increments.
7. Continue Pad: Select for the dehumidifier to operate continuously for
maximum dehumidification until the bucket is full. The Humidity set
control pads cannot be used when Continuous operation is on. Press this
pad again to cancel Continuous operation.
10