Electrical Connection; Power Supply - GUTMANN VIENTO Instrucciones De Uso

EN

7 Electrical connection:

WARNING OF ELECTRICAL ENERGY ! RISK OF FATAL INJURY !
Live components have been installed near this symbol. Covers bearing
this sign may only be removed by a certified skilled electrician.
The electrical connection must be carried out by a qualified electrician who is authorised to
carry out such work!
−
Statutory regulations and the connection specifications issued by the local power supply
company must be strictly observed.
−
When connecting the appliance it must be ensured that there is a device which makes it
possible to universally disconnect it from the mains with a contact opening width of at
least 3mm. Line-protecting switches, fuses or contactors are suitable cut-out devices.
When connecting and repairing the appliance disconnect it from the electricity supply
with one of these devices.
−
The earth wire must be sufficiently long so that if the strain relief fails, the live wires of the
connecting cable are subjected to tension before the earth wire.
−
Any superfluous cable must be removed from the installation area beneath the appliance.
−
Make sure that the local mains voltage is the same as the voltage on the rating label.
−
Full protection against accidental contact must be ensured on installation.
−
Attention: Incorrect connection may result in the power electronics unit being destroyed.

Power supply

Mains voltage:
380-415V 2N~, 50/60 Hz
220-240V 1N~, 50/60 Hz
Mains cable available in the factory
−
The hob has been fitted with a temperature-resistant connection cable in the factory.
−
If the mains cable of this appliance is damaged it will need to be replaced with a special
connection cable. In order to avoid any risks, this must be carried out by the manufactu-
rer or his Customer Service.
68
GENERAL TOPICS
Observe EN 60 335-2-6 / 2016-02 !